User manual SANGEAN PR-D8

[. . . ] When the DC jack ring stops flashing it should indicate that the batteries are fully charged. Important: When using rechargeable batteries, the battery switch must be placed in the NiMH/NiCad position. Decreased of power, distortion and "stuttering sound" are signs that the batteries may need to be recharged. Should the battery GB power decreases, the low battery power indicator will start flashing on the LCD display. [. . . ] By pressing tuning up/down button to select 24 hour format, complete the setting by pressing band/step button. Tuning steps in some countries are different from where you purchase the radio. If you buy the radio in Europe and intend to use in North America or South America, you may have to adjust the tuning step so, the radio may continue to serve you well. Upon resetting to the 12H/24H format the display will show FM and flash 50 kHz (tuning step) followed by a beep. By pressing the up/down tuning button, you may adjust it to100 kHz per tuning step then press band/step button again to complete FM tuning step reset. The display will show MW and flash 9 kHz after performing the FM tuning step reset. by pressing tuning up/down button , you may adjust to 10 kHz per tuning step. 5 mm headphone jack located on the left hand of your radio is provided for use with either headphones or an earpiece. The radio can be used as a separate tuner by connecting the input to Hi-Fi system, or using this input to make recording in stereo from audio program. The lock switch is used to prevent unintentional operation of the radio. This will prevent accidental operation when the radio is packed in a suitcase or carrying a pouch. To release the lock switch, simply move the switch to OFF position, the LOCK icon will be disappear from the display. The tone control switch is to adjust sound effect according to the program you are listening or playing back. Switch to Music position while you are listening to a music program and switch to news position while you are listening and playing back the recording from your voice. The PR-D8 is capable of recording selected audio program into an SD card on an MP3 format at selectable recording on and off time. Press and hold TIMER REC button until TIMER REC ON appears on the display and flashes hour digit. Press tuning up or down button to select the required timer recording on the hour then press TIMER REC button again and follow same procedure to set the minute. Switch the Timer Recording button which is located on your right hand side beneath volume control to ON position. When you select record from Aux In band, make sure the audio device (MP3 player or CD walkman) is plugged into Aux In jack and turn on the device. If you select timer recording from built-in microphone, press the band button to select SD. Press and release timer REC button to complete the timer recording setting. If the recording is from the device using AUX IN, the recorded folder will show as AUX IN and AUX file name. [. . . ] Do not leave the radio where there's excessive heat, which it could cause damage such as in a parked car. If at any time in the future you should need to dispose of this product please note that: Waste electrical products should not be disposed of with household waste. Een andere optie is het instellen van de LCD helderheid, door het drukken en loslaten van de knop om bright (helder), brighter (helderder), brightest (helderst) en off (uit) te selecteren. Als er meer dan één map is, dan zal, nadat alle bestanden in de huidige map zijn afgespeeld, de volgende map worden afgespeeld. [. . . ]