User manual SANGEAN PR-D7

[. . . ] Remove the battery cover on the back of the unit by sliding the cover in the direction of the arrow. Take care to ensure the batteries are inserted with correct polarity as shown inside the battery compartment. Important: when using alkaline batteries, the battery switch must be placed in the alkaline position. Failure to do so could result in serious damage to the batteries or radio. [. . . ] Whenever the adaptor is plugged into the radio and switched on the mains, the batteries are automatically disconnected. If the adaptor is plugged into the radio but not the mains is not switched on then the radio will run from the batteries if fitted. The AC adaptor should be disconnected from the mains supply and the radio when not is use. Display will show " - : - - " when the batteries are installed when the radio is connected to the mains supply. Press and hold the button for more than 2 seconds, display will flash time set symbol and also the hour digit, followed by a beep. This radio is equipped with three tuning methods ­ Scan tuning, Manual tuning and Memory presets recall. Press and release Scan button ( long press Scan button more than 2 seconds will activate time setting ), the radio will up search and stop automatically when it finds a radio station with good signal. The radio will continue to search next available stations if you do not press Scan button again when it finds a radio station. A single press on either the Tuning Up or Down button will change the frequency in the following increments: FM: 50 or 100 kHz AM (MW): 9 or 10 kHz 4. Press and hold either Tuning Up or Down button until the frequency in the display begins to change rapidly. Your radio will search the selected waveband and stop automatically when it finds a station of sufficient signal. Stations stored in preset memories can be overwritten by following above procedures. When the radio alarm is selected, the radio will turn on and play the chosen radio station at the chosen alarm time. The radio alarm will continue for an hour unless turned off by pressing the Power button. press the Power button whilst the alarm is activated will cancel the alarm for 24 hours. Note: Radio alarm can be activated only until both radio alarm time and radio alarmed station are set. Radio alarm will be automatically switched to buzzer alarm when the radio is in low battery status or the selected radio alarm station signal is too weak. Display Hour will flash, using Tuning Up/Down button to select the hour then press button again to confirm hour setting. Display will flash radio frequency last tuned, press Tuning Up/Down button to select required wake up radio station or simply press preset station button to select wake up station. Note: If new radio alarm station is not selected, it will select the last alarm station. The alarm beep will increase in volume every 15 seconds for one minute followed by one minute silence before repeating the cycle. The HWS alarm will sound for an hour until turning off by pressing the Power button. [. . . ] While radio is switched off, long press Band/Step button for more than 2 seconds will first show current FM tuning step. Another 5 seconds until display FM and 50 kHz ( tuning step ) flashing followed by a beep. by pressing Tuning Up/Down button , you may adjust to 100 kHz per tuning step. After FM tuning step is reset, pressing Band/Step button again, display will show MW and flash 9 kHz. [. . . ]