User manual SANGEAN PR-D5

[. . . ] The radio may fall, causing serious personal injury and damage to the radio. Ventilation: This radio should be situated so that its location or position does not interfere with its proper ventilation. For example, the radio should not be used on a bed, sofa, rug or other soft surfaces that may block the ventilation openings. [. . . ] Power button AUX In signal Band and Tuning step selection Alarm set CT Display LCD display Tuning/SET/AUTO SEEK knob Volume Control Preset buttons FM Stereo/Mono switch AUX IN socket Earphone socket DC input socket Antenna Battery compartment Clock can be set either the radio is power on or off. Press the SET knob (on the side of the radio) for more than 2 seconds, display will flash time set symbol and also the hour digits, followed by a beep. Rotate the Volume knob (on the side of the radio) to get required sound level. There are 5 memory presets for each waveband ­ STATION PRESETS 1 to 5. Stations stored in preset memories can be overwritten by following above procedures. This function only applies when FM station which is listening provides the RDS service. When FM station provides RDS service, shows on the display and the display shows the program type and then shows the radio text if radio text is provided. Press and hold CT button for more than 2 seconds until it beeps, then the radio clock time will be automatically corrected. Turn on the radio, and press the STEP/BAND button until "AUX" is displayed. To activate the alarm, press and hold the ALARM button for more than 2 seconds and it will beep and the display will show "ALARM". To deactivate the alarm, press and hold the ALARM button for more than 2 seconds and it will beep and the "ALARM" will disappear from the display. When the radio alarm is selected, the radio will turn on and play the last played radio station at the chosen alarm time. (If it is under AUX band, or the battery is low, then the alarm will sound by buzzer). The radio alarm will continue for one hour unless turned off by pressing the Power button. During radio alarm flashing, press the SET knob for more than 2 seconds followed by a beep tone, and the hour digits will flash. Rotate the SET knob to select the hour then press the SET knob to confirm hour setting, and the minute digits will flash. [. . . ] When this device been attach by static electricity, the display may show random codes ( meaningless characters ). To retrieve it, unplug the power and take out the batteries for more than 3 minutes, the display will be back to the normal. Power Requirements AC Power adaptor DC 9V 700mA center pin positive Batteries Battery Life 6 X UM-2 ( C size ) Approx . [. . . ]