User manual RUSSOUND KPSC

[. . . ] A second press of the Numeric button sends a Suffix command and puts the keypad back into the source control mode. If the button is not pressed a second time, a 3-second time out sends a Suffix command and exits Numeric control mode. They save current input and volume level settings for recall, and can be overwritten with another press and hold. Technical Specifications Dimensions: 1. 85"W x 2. 7"D x 1"H (4. 7 x 6. 9 x 2. 5 cm) Fits 1 Gang UL/CSA Approved 18 ci Junction Box 3 oz. (85 g) 12-pin connector KPSC Keypad The KPSC keypad is an in-wall, Decora® style single-gang keypad accessory designed to connect to a KP6 or KPL keypad (wall plate not included). [. . . ] To return for repairs, the unit must be shipped to Russound at the owner's expense, along with a note explaining the nature of service required. Be sure to pack the unit in a corrugated container with at least three (3) inches of resilient material to protect the unit from damage in transit. Before returning a unit for repair, call Russound at (603) 659-5170 for a Return Authorization number. Write this number on the shipping label and ship to: Russound, ATTN: Service, 5 Forbes Road, Newmarket, NH 03857 Due to continual efforts to improve product quality as new technology and techniques become available, Russound/FMP, Inc. reserves the right to revise system specifications without notice. Note: The KPSC keypad cannot be used with a CAS44 controller system. KPSC Keypad Front Panel 1 2 3 4 Numeric entry function of button is located on inner edge Primary source control function of button is located on outer edge 1 PRIMARY CONTROLS - Functions on outer edge of buttons are default or normal operation for each selected source. FAVORITES - Set and recall two favorite settings of source and volume. Numeric Prefix "Disc" and Suffix "Enter" commands are sent upon entering and exiting Numeric control. NUMERIC ENTRY - Once numeric value control is initiated, the buttons now represent the numeric value when pressed (0-9). Press Numeric button to enter or exit Numeric Entry Mode NOTE: 1. Exiting Numeric Entry Mode will send Suffix command All trademarks are property of their respective owners. 2 3 5 Forbes Road, Newmarket, NH 03857 tel 603. 659. 5170 · fax 603. 659. 5388 e-mail: tech@russound. com www. russound. com 28-1204 Rev. 1 11/02/05 4 KPSC Side Panel The KPSC 12-pin connector is located on the left side of the keypad (when facing front). This is covered when a trim plate is installed. Keypad Installation The KPSC connects to a KP6 or KPL keypad via a 12-pin connector. A double-gang electrical box and faceplate is required for installation. Check whether or not you can route the wire to the location you have chosen. To install a double-gang keypad, you will need to use a UL/CSA approved plastic two-gang (32 ci) electrical box. Route CAT-5 wire to the electrical box from the CAA66 system controller. Use a 110 punchdown tool to connect each wire to its corresponding color labeled on the KP6/KPL punchdown terminal. Insert the KPSC 12-pin connector into the 12-pin header on the other keypad. Safety Instructions 1. Read Instructions - All the safety and operating instructions should be read before the appliance is operated. Retain Instructions - The safety and operating instructions should be retained for future reference. Heed Warnings - All warnings on the appliance in the operating instructions should be adhered to. [. . . ] All other servicing should be referred to qualified service personnel. Precautions: 1. Power ­ WARNING: BEFORE TURNING ON THE POWER FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY. Do Not Touch The Unit With Wet Hands ­ Do not handle the unit when your hands are wet or damp. If water or any other liquid enters the unit's cabinet, take it to a qualified service person for inspection. Source 3. [. . . ]