User manual RUSSOUND ISSP

[. . . ] Install in accor- Warranty The Russound ISSP is fully guaranteed against all defects in materials and workmanship for two (2) years from the date of purchase. During this period, Russound will replace any defective parts and correct any defect in workmanship without charge for either parts or labor. [. . . ] In these cases, repairs will be made on the basis or the retail value of the parts and labor. To return for repairs, the unit must be shipped to Russound at the owner's expense, along with a note explaining the nature of service required. Be sure to pack the unit in a corrugated container with at least three (3) inches of resilient material to protect the unit from damage in transit. Before returning a unit, call Russound at 603. 659. 5170 for a return authorization number. Write this number on the shipping label and ship to: Russound, 5 Forbes Road, Newmarket, NH 03857. ISSP ComPointTM Speaker Instruction Manual dance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9. Do not defeat the safety purpose of the polarized or grounding plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 10. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where it exits from the apparatus. 11. 12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart-apparatus combination to avoid injury from tip-over. 13. Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as the power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, or the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. If you have any questions, call Russound at 1. 800. 638. 8055 or 603. 659. 5170. Product Overview The ISSP ComPointTM Speaker is a Decora®-style inwall speaker for use with the Russound ComPoint intercom system. [. . . ] On the other channel output, short the speaker terminals with a jumper. This is necessary because both channels of the keypad amplifier must be connected to produce an output signal, since the left and right channel outputs are wired in series. Typical Application Specifications Device: Single-gang Decora®-style in-wall* Grille: Perforated aluminum Driver: 1. 25" x 2. 5" (3. 2 x 6. 4 cm) water-resistant treated paper cone Connection: Attached wire leads Power rating: 2 watts nominal, 5 watts maximum Impedance: 8 ohms Sensitivity: 86 dB SPL ± 3 dB at 1 watt/1 meter Frequency response: 240 Hz ­ 15 kHz ± 10 dB Dimensions: 1. 65" W x 4. 13" H x 1. 42" D (4. 2 x 10. 5 x 3. 6 cm) Weight: 3 oz (85 g) *Wall plate not included L+ LOUT ISSP installed beside an ISK2 Advanced Keypad Connection Diagram R- R+ L+ L- IN R- R+ Shorting jumper ISSP connected to one channel output with shorting jumper on the other channel [. . . ]