User manual RUSSOUND ISK2

[. . . ] A built-in speaker relay allows it to share speakers with an audio system for high-fidelity communications. Wiring ComPoint system components interconnect with CAT-5 cable. If the ComPoint system is sharing speakers with an audio system, loop the speaker cables through the keypad locations. If dedicated speakers are being used, run the speaker cables to the keypads. When running CAT-5 and speaker cables, avoid running them near AC power wiring. [. . . ] When you release the Talk key, both the sending and receiving keypads sound a single ping to signal the person receiving can reply hands free within 7 seconds. After 7 seconds, the keypads sound a double ping to signal the end of the hands-free reply period. To reply to an intercom from another zone before the double ping, just speak. You can reply as long as the sending zone's label appears on the display. An intercom session is not allowed when there is a page, door station call, or other intercom session in progress. Also, a door station call takes precedence and thus interrupts an intercom session in progress. Listen to another zone You can use your ComPoint system to continuously listen to any single zone from one or more other zones. This is done by first turning on a keypad microphone in the zone you want to listen to, then selecting that zone on one or more other keypads. To turn on a keypad's microphone, use the Next or Previous key to select that keypad's own zone label. The Talk key lights up red and after 2 seconds the display shows MicOn to show the keypad microphone is active. To listen to the zone with the active microphone from other keypads, use the Next or Previous key to select that zone on the other keypads. Each display alternately shows the zone label and Listn to indicate the system is in Listen mode. To exit Listen mode, press any key other than Volume Up or Volume Down in the zone you're listening to. Other communication events have priority over Listen mode and thus interrupt listening to another zone. Safety Precautions For your safety, please read and follow these precautions before installing or using this product: Read instructions. Read and understand all the applicable instructions before installing or operating the product. Retain documents. Keep this manual in a convenient place for reference. Heed warnings. Be aware of all warnings on the product and in the instructions. Follow instructions. Install and use this product only as Paging To send a page, press and hold the Talk key and speak anytime Page appears in the keypad display. If the display shows a zone label instead of Page, first use the Next or Previous key to select Page before you press the Talk key. If the system is busy when you press the Talk key, the display indicates Busy and the Talk key blinks red for 7 seconds. When you press the Talk key, all keypads sound a single ping tone to announce your message. They also indicate which zone you're sending from by showing your zone's label on their displays. The zone indication remains for 30 seconds after you release the Talk key. [. . . ] To cancel DND mode, press any key other than Volume Up or Volume Down. The red DND light shuts off. such as radiators, heat registers, stoves or other appliances that produce heat. Use the right power. Don't connect the product directly to electrical line voltage. Use only the power adapter provided with the product, described in the product specifications or installation instructions, or as marked on the product. Ground product properly. [. . . ]