User manual RUSSOUND IRB-6

[. . . ] Instruction Manual 1 2 EMITTERS IRB-6 3 4 POWER STATUS Product Overview The IRB-6 provides an effective in-wall method to connect Infrared components. The IRB-6 can conenct up to 12 infrared receivers and allows control of up to 8 infrared controlled devices. [. . . ] IR receivers usually consume approximately 10mA ­ 15mA each, while most learning keypads consume approximately 50mA each. NOTE ­ The STATUS connection is for use with IR receivers or keypads that have Status feedback capability (see your IR receiver or keypad documentation). 5) Make sure that the drain wire of the cable is connected to the GND terminal of the main input connector on the back of the IRB-6. The drain wire does not need to be connected to the ground connection of the IR receiver or keypad. 3 IR Emitter Connections 1) Connect the 1/8" plug of either the Model #845 or #1584 emitter to one of the emitter outputs at the front of the IRB-6 as shown in Figure 2. When using the Model #1584 emitters, up to 8 IR controlled devices can be controlled. 2) Following the instructions that came with your IR emitter, place the other end of the IR emitter onto the IR sensor window of the equipment to be controlled. Power Supply and Status Input Connections 1) Connect the Model #846C Power Supply to the POWER connection at the front of the IRB-6 as shown in Figure 2. 2) Check all connections and then plug the power supply into an unswitched AC receptacle. The CONFIRM indicator located on the circuit board of the IRB-6 gives a visual indication that the signals from the IR receivers or keypads are being successfully transferred to the IRB-6. 4) If the installed IR receivers or keypads have Status feedback capability, another Model #846C Power Supply can be connected to the STATUS input at the front of the IRB-6 as shown in Figure 2. 4 Figure 2 ­ The power supply would be plugged into a switched AC receptacle, usually on the back of the audio receiver being used. Please read the IR receiver or keypad documentation for the details of this feature. TUNER Figure 2 Model 846C Power Supply To Unswitched AC Outlet DVD PLAYER 1 2 EMITTERS 3 4 CD PLAYER POWER Model 846C Power Supply To Switched AC Outlet of A/V Receiver STATUS SATELLITE RECIEVER Installation 1) Check all connections, and proper system operation before installing the IRB-6 into the wall. 2) Using the included hardware, install the IRB-6 into a standard electrical box. 5 Limited Warranty The Russound IRB-6 is fully guaranteed for Two (2) years from the date of purchase against all defects in materials and workmanship. [. . . ] Be sure to pack in a corrugated container with at least 3 inches of resilient material to protect the unit from damage in transit. 5 Forbes Rd. Newmarket, NH 03857, USA ¤ 603. 659. 5170 · Fax 603. 659. 5388 e-mail: tech@russound. com Come visit us at: 6 [. . . ]