User manual RUSSOUND CAV66 2

[. . . ] CAV6. 6-S2 System 6-Zone, 6-Source Audio/Video Controller Amplifier INSTRUCTION MANUAL IMPORTANT SAFEGUARDS 9. Heat - The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including amplifiers) that produce heat. 10. Power Sources - The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. 11. Grounding or Polarization - Precaution should be taken so that the grounding or polarization means of an appliance is not defeated. [. . . ] Flow Charts Installation Menu flow charts (pages 59-69) provide a graphical representation of the programming process. Installation Menu The Installation Menu (pages 47-58) provides the step-by-step complete programming procedure for the keypad and the controller. Although you can begin programming at any point within the Installation Menu, the following sequence is recommended for initial installations, as it progresses from the most basic requirements to the more advanced features. Controller Setup (CTRLR SETUP) (page 54) This procedure sets the controller ID number within the system. This number must be manually set when multiple CAV6. 6's are linked through R-NET within one system. Number of Sources (# of Sources/SOURCE SETUP) (page 53) This procedure sets the number of sources used in the system. This prevents the user from selecting a source input that is not used. Basic Setup (SOURCE SETUP) (page 48) This procedure is mandatory to set up each source for keypad source control and is the cornerstone of the programming process. 42 INSTALLER SYSTEM PROGRAMMING OVERVIEW 4. Learn IR (page 57) This procedure is used when the source-specific IR code is not found in the built-in IR code library. This allows IR commands to be learned into the system and centrally stored. Macro Editor (page 57) This procedure compiles multiple IR codes to be initiated by a single button press. One macro can have up to 10 commands, including other macros, and up to 132 macros can be entered. Source Volume Trim (SOURCE SETUP) (page 51) This procedure matches audio output signals for all sources for seamless switching. Numeric IR (SOURCE SETUP) (page 51) This procedure sets up control of a source that supports direct numeric commands. Key Configuration (SOURCE SETUP) (page 49) This procedure customizes individual key functions on a per-zone basis for source control. Power Management (page 55) This function incorporates IR macro commands to automatically control the power state of the sources when the system is in use or when a home theater is sharing sources. This advanced feature uses audio signal monitoring to confirm source power, which provides the user with worry-free operation. Zone Volume Trim (ZONE SETUP) (page 54) This procedure limits the maximum volume allowed in a zone, regardless of keypad volume adjustment. System On Enable (SYSON ENABLE/ZONE SETUP) (page 54) This feature allows a zone to join or opt out of an "all on" command. Party Enable (ZONE SETUP) (page 54) This feature allows a zone to join or opt out of Party Mode participation. Master Enable (ZONE SETUP) (page 54) This feature allows a zone the option of becoming a Master keypad in Party Mode. Page Enable (ZONE SETUP) (page 54) This feature allows a zone to hear or to block paging. [. . . ] The amplified output from zone 1 connects to the input on the back of the SRM-2. 1 speaker relay module. The Home Theater left and right front main speaker outputs are connected to the input on the front of the SRM-2. 1. Zone 1 12V Trigger output is connected to the 12V +/- on the back of the SRM-2. 1. When zone 1 is powered on, the SRM-2. 1 is triggered allowing audio from zone 1 of the CAV6. 6 to power the speakers. [. . . ]