User manual RUSSOUND CAS-RC

[. . . ] The remote sends IR codes from its library to the selected device, starting with the most popular code first. To search for other device codes, repeat steps 1-5. CHECKING THE CODES If you have set up the remote using the procedure in "Searching for Your Code, " you may need to find out which five-digit code is operating your equipment. Count the LED blinks (e. g. , three blinks =3), and enter the number in the appropriate device list in step 6 of "Programming a Device. " If a code digit is 0, the LED does not blink. Repeat step 4 for the remaining digits, using 2 for the second digit, and so on. [. . . ] If the batteries are inserted correctly, the LED will blink once. USING LEARNING The CAS-RC includes a Learning feature so you can add functions that are unique to your home entertainment devices (e. g. , VCR Tracking Up or Down). · The original remote controls must be in working order for learning to work properly. · Learned keys are mode specific, so each one can store a unique function for each mode. · Do not use the following keys for learning: Device Keys, SET, BACK, or Record. · Learning capacity is approximately 40 to 100 keys, depending on the code being learned. · Certain device codes are not learnable including multi-frequency types, some high frequency ones, and other unusual formats. · For optimum learning, avoid high levels of ambient light such as natural sunlight or energy-efficient fluorescent lights. · Have the original remote controls handy before programming learning. Programming a learned key Note: If more than 15 seconds pass between key presses, the remote exits programming. Press a device key once (e. g. , S1, S2, S3, S4) to assign a mode for learning. Place the CAS-RC head-to-head (about 2" apart) from your original remote control. Also locate the key (on original remote control) that will serve as the teaching function. The CAS-RC LED will turn off. Continue holding the key on the original remote until the CAS-RC LED blinks twice. Note: If the LED displays one long blink, a learning error has occurred. If the function is still not captured, press and hold SET to exit programming. Review the learning precautions listed above, or the Troubleshooting tips below, before beginning again at step 1. NOTE: If more than 15 seconds passes between key presses, the remote exits programming. Repeat steps 2-4 for another key on the same source, or press and hold SET to exit programming. ADDITIONAL INFORMATION The CAS-RC does not have any user-serviceable parts. Opening the case, except for the battery cover, may cause permanent damage to the CAS-RC. [. . . ] Select the next/previous chapter on some models of DVD players. Press LAST to recall the last-viewed channel. SEARCHING FOR YOUR CODE Note: S1, S2, S3, S4, Vol +/-, Mute and Power are the same for any source. All other buttons are dependent upon the device code associated with the source. If your device does not respond to the remote after trying all codes listed for your brand, or if your brand is not listed, try searching for your code: 1. 0 Cable (Cable Converters, Video Accessories, Satellite Receivers) 1 TV (TVs) 2 VCR (VCRs, DVD players) 3 Audio (Audio Amplifiers, Audio Amp/Tuners, CD players) Raise or lower the sound level. Press MUTE to turn the sound off or on. Move the cursor in the menu screens. Press OK to choose the high-lighted menu option. [. . . ]