User manual RUSSOUND A-MSS

[. . . ] SYSTEM POWER - The Power LED will be illuminated when the 24VDC power supply attached to the powered A-BUS hub is powered. IR - The red LED will flash when IR signals are received by the A-BUS keypad. This is used to confirm IR reception to the A-MSS. · Four stereo audio source inputs with loop outputs for sharing audio with another system (e. g. , stereo receiver) · Compatible with other A-BUS products · Four common IR outputs with confirmation LED · 12VDC trigger output Connect a set of RCA patch cables for each source from the A-MSS source audio output to the receiver's line-level audio input, keeping channel identity consistent. Note: The receiver must have at least four line-level stereo audio inputs to send all four sources for independent use by another system. A-BUS technology is a new, innovative method of providing high quality audio to remote locations with a single 8-conductor cable such as CAT-5. [. . . ] Connect the other end of the CAT-5 to the expansion In or Link In port of the A-BUS hub. For the completion of the A-BUS system, the A-KP2 keypads are connected to the A-BUS hub and speakers for each zone are connected to the A-KP2. CAT-5 is used for all connections with T568A RJ-45 terminations and 110 punchdown terminations for the keypads. A-MSS OVERVIEW The A-MSS is an A-BUS hub that provides four pairs of stereo RCA inputs to allow up to four audio source components to be distributed throughout the house. The A-MSS will allow you to select any of the audio sources (when used with Russound's A-KP2 keypad in multisource mode) and listen to it in any room where you have an A-BUS keypad installed. In addition, the A-MSS has a built-in infrared A-BUS® is a registered trademark of LeisureTech Electronics Pty Ltd Australia The Russound A-MSS is fully guaranteed for two (2) years from the date of purchase against all defects in materials and workmanship. For this warranty to apply, the unit must be installed and used according to its written instructions. During this period, Russound will replace any defective parts and correct any defect in workmanship without charge for either parts or labor. Accidental damage and shipping damage are not considered defects under the terms of this warranty. Russound assumes no responsibility for defects resulting from abuse or servicing performed by an agency or person not specifically authorized in writing by Russound. Damage to or destruction of components due to excessive power voids the warranty. To return for repairs, the unit must be shipped to Russound at the owner's expense, along with a note explaining the nature of the service required. Be sure to pack in a corrugated container with at least 3 inches of resilient material to protect the unit from damage in transit. Before returning a unit for repair, call Russound at (603) 659-5170 for a Return Authorization number. Write the RA number on the shipping label and ship to: Russound, ATTN: Service, 5 Forbes Road, Newmarket NH 03857 5 Forbes Rd. Newmarket, NH 03857, USA 603. 659. 5170 · Fax 603. 659. 5388 e-mail: tech@russound. com Come visit us at: 28-1149 Russound sells product only through authorized Dealers and Distributors to ensure that customers obtain proper support and service. Any Russound product purchased from an unauthorized dealer or other source, including retailers, mail order sellers and online sellers will not be honored or serviced under existing Russound warranty policy. Any sale of products by an unauthorized source or other manner not authorized by Russound shall void the warranty on the applicable product. CONNECTION DIAGRAM FOR A-MSS. DIAGRAMS ARE NOT TO SCALE. SAFETY INSTRUCTIONS Safety Instructions: 1. Read Instructions - All the safety and operating instructions should be read before the appliance is operated. Retain Instructions - The safety and operating instructions should be retained for future reference. Heed Warnings - All warnings on the appliance in the operating instructions should be adhered to. [. . . ] The appliance does not appear to operate normally; or A-H4P 4-ZONE, 1-SOURCE AUDIO STRUCTURED WIRING HUB V+ VL+ LR+ RIR ST B BW G GW O OW BL BLW V+ VL+ LR+ RIR ST V+ VL+ LR+ RIR ST LINK IN OUT POWER INPUT 1 2 3 4 POWER 2, 5A +24V A-PS E. The appliance has been dropped or the enclosure is damaged. KEYPAD OUTPUTS SYSTEM ON IR DESIGNED IN USA MADE IN CHINA CAT-5 A-KP2 CAT-5 CAT-5 14. Servicing - The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. Precautions: 1. Power ­ WARNING: BEFORE TURNING ON THE POWER FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY. [. . . ]