User manual ROSIERES RTF765

[. . . ] In the event of a malfunction, do not attempt to repair the appliance yourself, but contact a qualified technician. After using the cooktop, ensure the indicator on the knob is turned to the "off" position and close the mains gas delivery tap or the gas cylinder tap. Should you decide not to use the appliance any longer, before scrapping it make it unusable in accordance with current environmental health and safety laws, ensuring any parts which might constitute a danger to children are rendered harmless. The appliance data plate, with technical specifications, is positioned at a visible point under the safety cover and is also enclosed with this manual. [. . . ] Adjustment of the minimum After replacing the injectors, light the burner and take off the knob. Move the tap to the minimum position, insert a screwdriver in the rod and adjust as follows: screw in to decrease the flame, unscrew to increase the flame. In any case, the result should be a small flame which is uniform and regular along the entire crown of the burner. Finally, check that the flame does not go out when the tap is turned quickly from maximum to minimum position. For burners with safety valves, check that the flame slightly licks the thermocouple. Verify the correct adjustment by leaving the burner on for a few minutes. 15 Using the grates The cooktop grates have been designed to make the use of the product convenient and safe. We recommend that you check, before each use, the exact positioning and stability of the grate on the cooktop. Furthermore, check that the rubber supports are always intact and arranged correctly. 2) - Optional This is placed only over the grate of the auxiliary burner (the smallest one) when using cookware with a small diameter in order to prevent it from tipping over. 3) This is placed only over the grate of the triple crown burner when using a WOK (pan with concave bottom). To avoid causing serious anomalies in the burner operation, it is recommended that you do not use WOKs without this special grate and do not use the special grate for flat-bottom cookware. The appliance must be installed correctly and in compliance with current regulations. Any work on the appliance must be done with the appliance disconnected from the electrical power supply. Any operations requested from the Manufacturing Company as a result of incorrect installation are not covered by the guarantee. If the cooktop is being installed on an oven base, all the necessary precautions must be taken to ensure installation in compliance with safety regulations (CEI - UNI - CIG). Pay particular attention that the electrical cable and gas supply pipe are positioned so as to not come in contact with the hot parts of the oven casing. Furthermore, if an oven without a cooling fan is installed under the cooktop, it is necessary to make openings in the built-in unit to ensure proper air circulation. These openings must guarantee a free surface of at least 300 cm2 distributed as shown in figure 8. Installation in the top (surface of the furniture) The cooktop can be installed on all furniture, as long as it is heat resistant (withstanding temperatures up to at least 90°C). [. . . ] If the knobs become difficult to turn or the odour of gas is present, close the general tap and contact technical service. CUSTOMER ASSISTENCE SERVICE If you cannot identify the cause of the operating anomaly, switch off the appliance (do not subject it to rought treatment) and contact the Assistance Service. It is important you to inform the Assistance Service of your product code and its serial number (a 16 character code which begins with the number 3); this can be found on the guarantee certificate or on the data plate located on the appliance. P GB This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). [. . . ]