User manual ROSIERES RTF 765

[. . . ] After using the cooktop, ensure the indicator on the knob is turned to the "off" position and close the mains gas delivery tap or the gas cylinder tap. Should you decide not to use the appliance any longer, before scrapping it make it unusable in accordance with current environmental health and safety laws, ensuring any parts which might constitute a danger to children are rendered harmless. The appliance data plate, with technical specifications, is positioned at a visible point under the safety cover and is also enclosed with this manual. The data plate below the safety cover must under no circumstances be removed. [. . . ] The cooktop grates have been designed to make the use of the product convenient and safe. We recommend that you check, before each use, the exact positioning and stability of the grate on the cooktop. 2) - Optional This is placed only over the grate of the auxiliary burner (the smallest one) when using cookware with a small diameter in order to prevent it from tipping over. 3) This is placed only over the grate of the triple crown burner when using a WOK (pan with concave bottom). To avoid causing serious anomalies in the burner operation, it is recommended that you do not use WOKs without this special grate and do not use the special grate for flat-bottom cookware. The appliance must be installed correctly and in compliance with current regulations. Any work on the appliance must be done with the appliance disconnected from the electrical power supply. Any operations requested from the Manufacturing Company as a result of incorrect installation are not covered by the guarantee. If the cooktop is being installed on an oven base, all the necessary precautions must be taken to ensure installation in compliance with safety regulations (CEI - UNI - CIG). Pay particular attention that the electrical cable and gas supply pipe are positioned so as to not come in contact with the hot parts of the oven casing. Furthermore, if an oven without a cooling fan is installed under the cooktop, it is necessary to make openings in the built-in unit to ensure proper air circulation. These openings must guarantee a free surface of at least 300 cm2 distributed as shown in figure 8. Installation in the top (surface of the furniture) The cooktop can be installed on all furniture, as long as it is heat resistant (withstanding temperatures up to at least 90°C). The dimensions of the hole to make on the furniture surface and the minimum distances from the back and side walls and above the appliance are indicated in figures 5 and 6. Consider that: When the cooktop is installed without an oven beneath, it is mandatory to use a dividing panel between the bottom of the cooktop and the furniture underneath, at a minimum distance of 10 mm. If the cooktop is matched with an oven, place a partition at a minimum distance of 15 mm, while maintaining ventilation as specified in fig. In any case the electrical connection of the two appliances must be realized separately, both for electrical reasons as well as to facilitate their extraction. Fixing the cooktop The cooktop must be fixed to the furniture as follows: Position the appropriate sealing gasket provided with the cooktop along the external perimeter of the hole made in the furniture according to the diagram in fig. [. . . ] Enamelled parts All enamelled parts must be washed only with a sponge and soapy water or using other non-abrasive products made specifically for enamelled surfaces. Stainless steel surface The stainless steel surface should be cleaned with a damp cloth and specific products easily found on the market. The stainless steel reducer may take on a bluish colouring in the burner area due to the temperature. This effect may be attenuated using common stainless steel sponges available on the market. [. . . ]