User manual ROSIERES RSB94

[. . . ] - If the cable is damaged, replace it as soon as possible with another one which has the same characteristics and which is suitable for use at the power level of the appliance. A) Do not check the status of the filters while the cooker hood is operating B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. C) Flambè cooking is prohibited underneath the cooker hood D) Avoid free flame, as it is damaging for the filters and a fire hazard E) Constantly check food frying to avoid that the overheated oil may become a fire hazard F) Disconnect the electrical plug prior to any maintenance. [. . . ] 3) in such a way that it is in line with your hood and respecting the distance from the ceiling indicated in Fig. Connect the flange C to the air exhaust hole using a connection pipe (Fig. 4), extract the upper flue up to the bracket and fix it with the screws B (Fig. To transform the hood from a ducting version into a filtering version, ask your dealer for the charcoal filters and follow the installation instructions. € FILTERING VERSION Install the hood and the two flues as described in the paragraph for installation of the hood in ducting version. To assemble the filtering flue refer to the instructions contained in the kit. The filters are not washable or re-usable and must be replaced at least once ever y four months. The active carbon filter saturation level depends on the frequency with which the appliance is used, the type of cooking performed and the regularity with which the anti-grease filters are cleaned. € Clean the cooker hood frequently, both inside and outside, using a cloth which has been dampened with denatured alcohol or neutral, non-abrasive liquid detergents. € The light on the cooker hood is designed for use during cooking and not for general room illumination. The appliance switches on at speed level 1, If the cooker hood is on depress the push-button for 2 sec. If the cooker hood is at speed level 1 it will not be necessary to depress the push-button to switch the cooker hood off. Display C = indicates the motor speed level selected and activates the timer. Touching the key at 3rd speed, the intensive function runs for 10', then the appliance go back to work at the original speed. Key E = The Timer times the functions on activation for 15 minutes, after which they are switched off. When the Timer is activated the decimal point must flash on the display. [. . . ] If key D is pressed the “clean air” function is deactivated and the motor moves to the 2nd speed straight away. € Active carbon/grease filter saturation: - When button A flashes at a frequency of 2 seconds, the grease filters must be cleaned. After the clean filter has been replaced, the electronic memory must be reset by pressing button A for approximately 5 seconds, until the light on the button stops flashing. [. . . ]