User manual ROSIERES RHV9185IN

[. . . ] B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. D) Avoid free flame, as it is damaging for the filters and a fire hazard. E) Constantly check food frying to avoid that the overheated oil may become a fire hazard. G) This appliance is not intended for use by young children or infirm persons without supervision. [. . . ] € Filtering version: Install the hood and the two flues as described in the paragraph for installation of the hood in ducting version. To assemble the filtering flue refer to the instructions contained in the kit. 9): If the appliance version is with LED lamps, the intervention of a specialised technician is necessary to replace them. The “filter alarm” can be reset by pressing the button for a few seconds. Button B = Switches the appliance on/Decreases the extraction rate of the motor. The appliance can be switched off by pressing the “D” button for a few seconds. Automatic extraction function: With this function the appliance automatically adjusts the motor’s extraction rate according to the quality of the air below thanks to the sensor located under the cooker hood (Fig. To activate this function, press the “B” button for a few seconds. When you switch on the cooker hood you will need to wait a few seconds, depending on the sensor’s setting, before the automatic extraction function is activated. If the function has not been activated yet, there will be a decimal point flashing on the display. Setting the sensor: According to the type of hob (gas or electric) it is possible to increase the effectiveness of the sensor by matching the cooker hood with the right hob. To carry out this operation, press the “B” and “D” buttons together for a few seconds with the motor off. - To match the cooker hood with a gas hob, press the “B“ button. a “P” and a “0” will alternate on the display. - To match the cooker hood with an electric hob, press the “D“ button. a “P” and a “1” will alternate on the display. To complete the setting, press the “B+D” buttons for a few seconds. The appliance has already been set for an electric hob by the manufacturer. Intensive: This function allows you to temporarily increase the motor’s extraction rate for about 10 minutes. To activate the function, press the “D“ button after selecting extraction rate level 3. After 10 minutes, the appliance will return to operate at extraction rate level 3. Timer: This function allows you to set the appliance to run for 15 minutes and then switch off. [. . . ] Filter Alarm: • Saturation of Anti-grease Filters: This function is activated after the appliance has been running for approximately 30 hours. The letter “F” and the current extraction rate level will alternate on the display. To reset the function, press the “A” button for a few seconds. € Saturation of Carbon Filters: This function is activated after the appliance has been running for approximately 120 hours. [. . . ]