User manual ROSIERES RHV912IN

[. . . ] B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. D) Avoid free flame, as it is damaging for the filters and a fire hazard. E) Constantly check food frying to avoid that the overheated oil may become a fire hazard. G) This appliance is not intended for use by young children or infirm persons without supervision. [. . . ] - Take the upper chimney piece and fix it to the structure using the 2 screws A (Fig. Join the lower chimney piece with the upper one and fix it carefully using adhesive tape L (Fig. Insert the suction unit inside the structure paying attention that the previously unscrewed screws O, hook into the slots in the lower part as indicated in (Fig. - Fix the air evacuation pipe H (not supplied) onto the connection flange F (Fig. - Remove adhesive tape L and rest the lower chimney piece above the cooker hood (Fig. - If the cooker hood is supplied with a lower chimney piece that must be fixed to the hood body with screws, remove the anti-grease filters from the hood by acting on the relevant handles (Fig. Then screw the lower chimney piece pipe to the inside of the hood, using screws P (Fig. 17): To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. 18): If the appliance version is with LED lamps, the intervention of a specialised technician is necessary to replace them. The “filter alarm” can be reset by pressing the button for a few seconds. Button B = Switches the appliance on/Decreases the extraction rate of the motor. The appliance can be switched off by pressing the “D” button for a few seconds. Automatic extraction function: With this function the appliance automatically adjusts the motor’s extraction rate according to the quality of the air below thanks to the sensor located under the cooker hood (Fig. To activate this function, press the “B” button for a few seconds. When you switch on the cooker hood you will need to wait a few seconds, depending on the sensor’s setting, before the automatic extraction function is activated. If the function has not been activated yet, there will be a decimal point flashing on the display. Setting the sensor: According to the type of hob (gas or electric) it is possible to increase the effectiveness of the sensor by matching the cooker hood with the right hob. To carry out this operation, press the “B” and “D” buttons together for a few seconds with the motor off. - To match the cooker hood with a gas hob, press the “B“ button. a “P” and a “0” will alternate on the display. [. . . ] € Clean the cooker hood frequently, both inside and outside, using a cloth which has been dampened with denatured alcohol or neutral, not-abrasive liquid detergents. € The light on the cooker hood is designed for use during cooking and not for general room illumination. Extended - 13 - med and how often the anti-grease filters are cleaned. To activate the filter alarm function, press the “A+E“ buttons together. [. . . ]