User manual ROSIERES RHV 994 IN

[. . . ] Permanently fix the cooker hood to the suction group with the 12 screws. Using a pencil, draw a line on the wall, extending up to the ceiling, to mark the centre. [. . . ] Only if the control panel is already mounted on the lower flue: The pin of the small plate MUST correspond to the hole made in the connection plinth on the electronic box (20d). Slide the bottom section of the chimney down until it completely covers the suction unit and slots into the housing provided on top of the hood. Prior to any maintenance operation ensure that the cooker hood is disconnected from the power supply. Warning: Failure to carry out the basic standards of the cleaning of the cooker hood and replacement of the filters may cause fire risks. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. 2 This must be cleaned once a month (or when the filter saturation indication system ­ if envisaged on the model in possession ­ indicates this necessity) using non aggressive detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity. The charcoal filter can be washed once every two months (or when the filter saturation indication system ­ if envisaged on the model in possession ­ indicates this necessity) using hot water and a suitable detergent, or in a dishwasher at 65°C (if the dishwasher is used, select the full cycle function and leave dishes out). Eliminate excess water without damaging the filter, then remove the mattress located inside the plastic frame and put it in the oven for 10 minutes at 100° C to dry completely. remove the filter holder frame by turning the knobs (g) 90° that affix the chimney to the cooker hood. Insert the pad (i) of activated carbon into the frame (h) and fit the whole back into its housing (j). It is possible to use a traditional carbon filter, neither washable nor regenerable, to be replaced every 3 - 4 months. The filter holder frame of the carbon filter is welded together; the eventual frame supplied with the hood is not, therefore, to be used. Use a small screwdriver as a lever on the borders of the lamp in order to remove the lightbulb. [. . . ] Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. [. . . ]