User manual ROSIERES RHT6300LIN

[. . . ] If a connection tube composed of two parts is used, the upper part must be placed outside the lower part. Do not connect the cooker hood exhaust to the same conductor used to circulate hot air or for evacuating fumes from other appliances generated by other than an electrical source. Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig. - In the case of assembly of the appliance in the suction version prepare the hole for evacuation of the air. [. . . ] E) Constantly check food frying to avoid that the overheated oil may become a fire hazard. G) This appliance is not intended for use by young children or infirm persons without supervision. H) Young children should be supervised to ensure they do not play with the appliance. I) There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels. L) There is a risk of fire if cleaning is not carried out in accordance with the instructions. This appliance conforms to the European Directive EC/2002/96, Waste Electrical and Electronic Equipment (WEEE). By making sure that this appliance is disposed of in a suitable manner, the user is helping to prevent potential damage to the environment or to public health. -9- which are suitable for the type of cabinet, making holes in accordance with the diagram shown in Fig. To fit the appliance correctly, align the front panel of the cooker hood with the cabinet door and adjust spacer L using screws P (Fig. € Extraction through an outside wall: The appliance expels the fumes through an outside wall or a duct. It is necessary to buy a telescopic pipe in accordance with the standards in use (inflammable) and connect it to flange H (Fig. € Recirculation: To transform the cooker hood from the extraction version to the re circulating one ask your supplier for an activated carbon filter. The filter must be fitted to the extracting group cooker hood in the centre of the fan grille by twisting it by 90 degrees until it is gripped securely (Fig. The clean air is returned into the room through a connecting tube passing inside the cupboard and connected to the ring H (Fig. Prolonged use of the lighting system significantly decreases the average duration of the bulbs. € If the appliance is equipped with courtesy lights it is possible to use them for general room lighting for a prolonged amount of time. € Attention: the non compliance with the hood cleaning warnings and with the replacement and cleaning of the filters entails risk of fires. 6): To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. 7) slider the key symbols are explained below: A = Light switch A1 = Off key A2 = On key B = Speed control B1 = Off key B2 = FIRST SPEED key B3 = SECOND SPEED key B4 = THIRD SPEED key C = Gemma warning light key. 8): Only use lamps of the same type and wattage installed on the device. 9) slider the key symbols are explained below: This hood is fitted with a microswitch which allows the activation of the motor speed) through the opening of the telescopic undercarriage. If the telescopic undercarriage is closed the motor speeds cannot be activated. [. . . ] The saturation of the active charcoal depends on the more or less prolonged use of the appliance, on the type of kitchen and on the frequency with which antigrease filter is cleaned. - Regenerable active charcoal filters must be washed by hand, with non abrasive neutral detergents, or in the dishwasher at a maximum temperature of 65°C (the washing cycle must be complete without dishware). Remove excess water without damaging the filter, remove the plastic parts, and let the mat dry in the oven for at least 15 minutes approximately at a maximum temperature of 100°C. To keep the regenerable charcoal filter functioning efficient this operation must be repeated every 2 months. [. . . ]