User manual ROSIERES RHT 619 IN

[. . . ] In case your appliance is not furnished with a non separating flexible cable and has no plug, or has not got any other device ensuring omnipolar disconnection from the electricity main, with a contact opening distance of at least 3 mm, such separating device ensuring disconnection from the main must be included in the fixed installation. Always switch off the electricity supply before carrying out any cleaning or servicing operations on the appliance. To clean the inside of the appliance, use a cloth (or brush) dipped in denatured ethyl alcohol. [. . . ] When using the filtering version of the appliance, the actived carbon filters must be changed according to use (Fig. Remove the filters rotating them and replace them rotating into the opposite direction. Light bulb If the fluorescent light need changing, slacken the light cover by disconnecting the screw and remove the bulb itself (Fig. To change the rectangular halogen bulbs open the cover and remove the bulb without touching it with bare hands (Fig. 7: Take the two brackets (S) out of the accessory bag together with the 12 screws provided. Fit the brackets to the wall unit being careful to position these correctly; for this operation use the 8 shorter screws. At this point, secure the appliance to the brackets using the 4 longer screws. Ducting version: connect the flange of the hood with the air venting hole made previously in the wall/ceiling by means of an adequate tube. Filtering version: connect a proper pipe to the flange of the hood so that the air is sent outside the pensile and sent back into the room. Opening slightly the truck, the motor works at the I speed; opening a bit more, the motor works at the II speed; opening totally the truck, the motor works at the III speed. Position L: the lights switch ON and the motor switch OFF either if the truck is open or closed; the motor is always OFF. When the switch is in M or T position, opening the truck, the motor starts working automatically at the selected speed. 6: Met behulp van de boormal de 4 bevestigingsgaten voorzien volgens uw model in de bodem van de kast en de nodige opening voor de buitenafvoer van de lucht uitsnijden. The distance between the supporting surface for the cooking vessels on the hob and the lower part of the hood must be at least 65 cm. [. . . ] Avoid using materials which could cause spurts of flame (flambées) near the appliance. When frying, take particular care to prevent oil and grease from catching fire. To avoid possible risks of fire always comply with the indicated instructions when cleaning anti-grease filters and when removing grease deposits from the appliance. [. . . ]