User manual ROSIERES RHI 9101 SP IN

[. . . ] It is also advisable to avoid any drastic changes in pipe section (diameter: 150 mm). ASSEMBLING - Using the special drilling template, drill the holes for fixing to the ceiling on the vertical side of your hob. Carefully observe all the indications for final positioning of the apparatus. Take into account that one of the template axes must correspond to the axis of the hood controls. [. . . ] Adjust the height of the telescopic structure by means of the four retaining screws C (Fig. 6), taking into account that the height of the hood is 45 mm and that the distance between the hood and the hob must be at least 650 mm (Fig. 13), fit the flange (G) to the baffle (F) locking it with a turning movement. Take the upper flue (with the round slots) and fit it on the telescopic structure with the slots facing upwards; fit the flue to the bracket with 2 screws (Fig. Take the lower flue and fit it in the same manner as before; slide it to the top and stop it in that position using a adhesive tape (Fig. 14L) and assemble it onto the air venting opening of the hood, pressing slightly. Fit the hood to the telescopic structure by means of 4 screws (provided) ?Remove the adhesive tape and pull the lower flue downwards, placing it gently onto the apparatus. Fitting the charcoal filter: Turn the glass panel gripping it from the font part of the hood (Fig. Remove the grease filter by pushing the catch towards the rear of the hood and turning the filter outwards. 17) by inserting the two filter clips in the slots and turning the filter towards the inside of the hood. Switch on the motor to the latest used speed and if pressed different times changes the speed in a cyclic way (1, 2, 3, 4, 1, 2?. ) The speed set is visualized by the icon D5 and simultaneously the icon D8 switches on ( the speed of the rotational movement is proportional to the speed ). To the maximum speed the icon D8 switches off and the icon D3 switches on. To switch off the motor, press the push button P2 for about 2 seconds (the set speed is memorized). Push button P3: Select the functions D4 (Sensor) and/or D7 (Air Refresh). It switches on when the grease filter must be cleaned (after about 30 hours of working). One time the grease filter is cleaned, to make the hours calculation start again, press the push button P4. Icon D4: SENSOR: To activate the sensor function, press the push button P3. When the sensor activated, the hood switches on automatically in the presence of any kinds of odours or vapours, smokes or heat, caused by the cooking process and also in the presence of possible and anomalous gas emissions in environment. [. . . ] Grease filters: the grease filter/s require particular care and must periodically be cleaned in relation to use. 18) appears on the control display every 30 hours of hood operation to indicate that the grease filter/s need to be cleaned. Remove the grease filter by pushing the catch towards the rear of the hood and turning the filter outwards. Charcoal filters: If using the hood in the filtering version, the charcoal filter will periodically have to be replaced in relation to use. [. . . ]