User manual ROSIERES RHI 693 SP

[. . . ] 1A) must be used, which placed at the top of the structure, allows the air to recycle back into the room. In the Ducting version, cooking vapours and odours are conveyed straight outside by a disposal duct which passes through the ceiling (Fig. [. . . ] Bear in mind that one of the axes of the drilling jig must correspond to the axis of the hood controls. - Separate the upper from the lower telescopic structure by removing the screws (C) and washers (Fig. 11) and connect a flexible hose locking it with a metal clamp (hose and clamp are not provided). - Secure the upper telescopic structure to the ceiling using the screws and screw anchors provided (Fig. - Fit the lower telescopic structure and secure it to the upper one with 8 screws (C) and washers (Fig. Pay attention as positioning of the structure determines the final position of the hood: the opening B must be at the front. 5 bearing in mind that the distance between the hood and the hob must be at least 650 mm. - Take the upper part of the hood (pipe with slots) and fit it on the telescopic structure with the slots at the top (Fig. Secure the lower part of the hood to the upper part, inserting the 4 pins (F) in the holes and lock everything with 4 nuts and 4 washers (Fig. - Install the charcoal filters: Hook them onto the sides of the duct and turn them towards the rear of the hood (Fig. At this point, installation has been completed and the grease filter can be fitted. D) Drives the motor (calling the last speed used) and increases the speed until reaching maximum. L) Display: - signals the running speed - signals Automatic mode by displaying the letter "A". When the motor speed is changed, the running speed is displayed flashing 3 times, and then the letter "A" reappears. [. . . ] Removing the charcoal filters: Open the metal panel gripping it at the front part and turning it downwards (Fig. Remove the grease filter by pushing the catch and turning it downwards (Fig. [. . . ]