User manual ROSIERES RHE62

[. . . ] Vapour collector remain visible on the letter C of the drill holes diagram) drill B. Light point Where the side cabinet thickness is 16mm apply spacers if supplied (Fig. 1: The cooker hood is supplied with an upper air corresponding to the drill holes specified for the screws. [. . . ] 1), depending on the model turn the lateral Caution: This appliance is designed to be operated by handles and remove the grill by sliding towards the bottom adults. 2) or pull the handles upwards and slide out the controls or play with the appliance. 2), remove the vapour collector Do not use the cooker hood where the grill is not correctly (freeing the locking releases I-Fig. The suctioned air must not be conveyed in the same diagram N3 on the rear of the aesthetic panel (Fig. 4, J-the channel used for fumes discharged by appliances powered arrow on the diagram should face the upper border of the by other than electricity. The environment must always be aesthetic panel), perform blind holes as indicated (Kadequately aerated when the cooker hood and other Fig. 4), place the vapour collector over the aesthetic panel appliances powered by other than electricity are used at and affix with 8 screws (Fig. Flambé cooking with a cooker hood is cooker hood firstly in the upper track (Fig. 4-M2), where the cooker hood is provided and may cause fire accidents, therefore free flame cooking must be avoided. Frying of foods must be kept under close with revolving locking releases (Fig. 3) these should be control in order to avoid overheated oil catching fire. Carry turned in the opposite direction of the release to avoid that out fumes discharging in accordance with the regulations the vapour collector may be unintentionally released during in force by local laws for safety and technical restrictions. Affixing the cooker hood to side cabinets use the drill Operation holes diagram N2, position the diagram on the anterior All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. Consult the designs in the front pages referenced in the text by alphabet letters. [. . . ] 8, Z) for centring the filter) covering the motor protection grill ensuring that the reference (Fig. 8, A2) on the conveyor, turn clockwise; for dismounting the carbon All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. Lamp replacement : Remove the suction grill (or directly open the lamp area if provided with release hooks D1-Fig. [. . . ]