User manual ROSIERES RHDC 918

[. . . ] Remove the telescopic chimney support M by unscrewing the side screws R (one on each side - these screws must be kept). Remove the air pipe L from the telescopic chimney support M; to do this, unscrew the The air is filtered through a carbon filter (for its installation see paragraph "Carbon filter") and recirculated into the room through the grating on the chimney. If the hood is not supplied with carbon filter, then it must be ordered and mounted. This version is used when there is no exhaust duct for venting outdoors or when it is impossible to install one. [. . . ] This version is used when there is no exhaust duct for venting outdoors or when it is impossible to install one. When installed, the distance between hood and burners must be not less than 65 cm. Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood It is advisable to call a qualified technician to make the electrical connection. Four screws (Ø 2, 9 x 9, 5 mm) fixing the air pipe to the support (these screws must be kept). Fit the telescopic chimney support to the wall, at a point close to the ceiling. The telescopic chimney support has a reference mark P, which must coincide with the line that you have already drawn on the wall. Using a pencil, mark the two holes required to fix the support, and drill the holes (Ø 8 mm). Insert two plugs and fix the telescopic chimney support M using 2 screws size (5x45 mm). During installation the plug must not be connected to the power supply. Select the hood operating mode Versione aspirante Fix the 150 mm diameter ABS pipe to the hood outlet and ensure that the other end discharges into the open air. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. It's function is to retain the grease particles The grease filter has an unlimited life span and must be washed by hand or in the dishwasher (65°) with suitable detergents. When washed in the dishwasher the grease filter may discolour but the filtration characteristics will not be effected. The grease filter must be washed at least once a month or each time the letter F or alternatively the selected velocity appears To disassemble the grease filter use the appropriate handles, first pull the handle back (a) and then down (b) Fig. After having washed the grease filter reverse the steps used to disassemble the grease filter in order to reassemble. Once the grease filters have been set in place and simultaneously for about press button three seconds until the letter F shown on display disappears. Children should not be allowed to tamper with the controls or play with the appliance . -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. [. . . ] Children should not be allowed to tamper with the controls or play with the appliance . -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. The use of an unprotected flame is dangerous for the filters and could cause fires. [. . . ]