User manual ROSIERES RHD 7 S

[. . . ] Once regulation has been completed, finish securing the hood with 4 more screws (M): mark the points for the 4 holes on the wall, remove the hood and drill (8mm diameter holes); then use the plugs and screws to complete installation. Rest the lower edge of the panel behind the stove and anchor the upper edge to the wall using the two holes found on the panel. The unit is secured to the rear panel as though it were being installed on the wall: use the supplied metal bracket (B) and the screws and plugs supplied with the panel. [. . . ] After 120h LED L2 becomes flashing RED Reset by means of P3 SENSITIVITY: In manual mode, by pressing P5 and P4 together, sensitivity mode is entered. By pressing P5 the sensitivity can be stored, with return to manual mode CONTROLS shown in Fig. 16: P1- Lights ON/OFF; filter alarm RESET: if held pressed down for about 2 seconds when the filter alarm is active, the hour counter is reset. Filter alarm: after 30 hours the light button LED comes on and stays on for 30 seconds; after 120 hours it is activated for 30 seconds but with the LED flashing. The RESET is highlighted ONLY when the motor is OFF, both in automatic and manual mode. Automatic function: To activate the automatic function press P2, highlighted by the corresponding LED coming on; the flashing LED indicates that the sensor is waiting for data. To set the sensitivity: in manual mode and with the motor off press P2 and P3 simultaneously; the sensitivity already set with the P3 or P4 or P5 LEDs is highlighted. to modify it , press P3 or P4 or P5 (MIN , MED , MAX) , and again press P2 to store it. At this point, the desired sensitivity has been stored; press P2 again to deactivate the automatic mode. Press P3 when in manual mode to turn on the motor in 1st speed with the relevant LED on. Press P4 to go to 2nd speed with the relevant LED on and P5 to go to 3rd speed with the relevant LED on. Grease filters: special attention must be given to the grease filters which must be periodically cleaned, whenever the grease filter alarm trips. Charcoal filters: if the filtering version appliance is used, the charcoal filters will have to be periodically replaced when the charcoal filter alarm trips. for instructions on the filter Alarm , refer to the Controls paragraph. Removing the charcoal filter/s: first of all, remove the grease filters; push the catch inwards (Fig. Lighting: to change the halogen bulbs open the cover levering from the proper slots (Fig. [. . . ] Avoid using materials which could cause spurts of flame (flambées) near the appliance. When frying, take particular care to prevent oil and grease from catching fire. To avoid possible risks of fire always comply with the indicated instructions when cleaning anti-grease filters and when removing grease deposits from the appliance. [. . . ]