User manual ROSIERES RHD 6 IN

[. . . ] Located in the upper part of the flue, this baffle recycles the air to the environment (Fig. 2) an exhaust duct conveys the steam and cooking odors directly outside through the wall/ceiling. INSTALLATION Remove the grease filters before proceeding with the assembly instructions. [. . . ] Rest the lower edge of the panel behind the hob and fix the upper edge to the wall by means of the two holes in the panel itself, inserting the supplied screws and screw anchors (A). The appliance should be fixed to the rear panel in the same way as wall fixing, using the supplied hood brackets and the screws and screw anchors supplied with the panel (B). Set the electrical power supply within the space covered by the decorative flues. If your unit is installed in Ducting version, prepare the air exhaust hole. In the Ducting version, to get optimal conditions the air venting pipe should: ?be made of material approved by local authorities (according to the State). It is moreover recommended to avoid drastic changes of pipe cross section (recommended diameter: 150 mm). Using the supplied screws and screw anchors, fix the upper flue bearing bracket to the ceiling and/or wall, checking that it is aligned with the hood (Fig. Prepare the decorative flues, remembering that their final position must be that illustrated in Fig. The air disposal gratings in the filtering version must be positioned in the upper part. For the ducting version turn upside down the upper flue so that the air disposal gratings are downwards. Ducting version : Connect the air outlet pipe to the air vent of the hood. Use a flexible pipe and lock it to the air vent of the hood with a metal hose clamp (pipe and clamp are not provided). Take the telescopic flues and check that they are coupled properly: the openings in the upper flue must be positioned at the bottom so that they are hidden; if necessary, turn around the upper flue. Lift the upper flue up to the ceiling and fix it to the bracket with the 2 screws (A) ?Filtering version : Separate the telescopic flues and take the upper flue (the one with the air openings) and fix the baffle to it with the 4 screws provided (Fig. [. . . ] When using the filtering version of the appliance, the charcoal filters must be changed according to use, usually every six months. Remove the filters rotating them and replace them rotating into the opposite direction (Fig. 12: to change the light bulb, remove the cover after having desinserted the locking screw. [. . . ]