User manual ROSIERES RHD 5 IN

[. . . ] Remove the grease filters before proceeding with the assembly instructions. 3): this is carried out by pushing the relative catch inwards and turning it downwards until it disengages from the supports. [. . . ] - Use a flexible pipe and lock it to the air vent of the hood with a metal hose clamp - Fig. ­ Move the 2 telescopic flues close to the hood and re-attach the cable to the control box (Fig. ­ Gently place the 2 telescopic flues on the hood in such a way that the fins on the hood remain inside the flue (Fig. ­ Lift the upper flue up to the ceiling and fix it to the bracket with 2 screws (Fig. INSTALLATION IN FILTERING VERSION: Prepare the power supply within the telescopic chimney (for the electrical connection, follow all the other instructions on the "Warnings" sheet). Fixing to the wall: for fixing to the wall refer to the instructions for the ducting version (see point 1, 2, 3), then continue with the instructions below. Fixing the telescopic flues: - Adjust the width of the support bracket (D) of the telescopic flue by means of the screws (E) as shown in Fig. - Then, by means of the screw anchors and screws (F) provided, fix the bracket to the ceiling in such a way that it is positioned along the axis with your hood. ­ Take the air baffle and fit a flexible pipe to it (125 mm diameter) locking it with a metal hose clamp (pipe and clamps are not provided). - Gently place the 2 telescopic flues on the hood in such a way that the fins on the hood remain inside the flue (Fig. - Lift the upper flue up to the ceiling and fix it to the bracket with 2 screws (Fig. ­ Lift the lower flue upward and lock it temporarily with some adhesive tape: that way you can access the flexible pipe which must be connected to the flange on the air vent (Fig. [. . . ] 3): this is carried out by pushing the relative catch inwards and turning it downwards until it disengages from the supports. Once the cleaned filters are reinstalled, to reset the counter hold the light button pressed down for about 1" (Fig. [. . . ]