User manual ROSIERES RHD 4 IN

[. . . ] In addition, exhaust air should not be discharged into a wall cavity, unless the cavity is designed for that purpose. The room must be well aerated in case a hood and some other heat equipment fed with an energy other than electricity (gas, oil, coal heaters, etc) operate at the same time. In fact the intake hood, disposing of air, could create a vacuum in the room. [. . . ] Positioned in the upper part of the flue, this allows the air to be recirculated throughout the room (Fig. 2), cooking vapours and odours are conveyed straight outside by a disposal duct which passes through the wall/ceiling. Wall fixing with brackets Make all the necessary holes on the wall using the relative boring template. Apply the supplied brackets to the wall using the relative screws and screw anchors (Fig. 5A) have been sufficiently slackened to allow the hood itself to be fitted in place. Now fit on the hood using the relative rectangular slots situated at the rear of the appliance (Fig. Since these coupling slots are dimensionally larger than the brackets, the horizontal position of the appliance can be adjusted by sliding to the right or left in order to align the equipment. The appliance can be regulated in height by means of the relative bracket adjuster screws (Fig. Once having regulated the equipment, fix everything in place by tightening screws A (Fig. Particular care must be paid to the antigrease filters which must be periodically cleaned in relation to use (at least once every two months). Remove the anti-grease filters and wash them either by hand or in the dishwasher using neutral detergent. Any fat deposits should be removed from the appliance periodically depending on amount of use (at least every 2 months). To clean painted appliances on the outside, use a cloth dipped in lukewarm water and neutral detergent. To clean steel, copper or brass appliances on the outside, it is always best to use specific products, following the instructions on the products 3), the appliance must be connected to an ducting apparatus/motor which works on its own using the appliance as a union for the air to be scavenged. [. . . ] If the halogene bulbs need changing, slacken the ring nut in an anticlockwise direction and remove the bulb itself (Fig. To change the rectangular halogene bulbs open the cover and remove the bulb without touching it with bare hands (Fig. Filtering version: ­ Prepare the telescopic flues, remembering that their final position must be that illustrated in Fig. [. . . ]