User manual ROSIERES RHD 1 IN

[. . . ] The reference point "a" marked on the body of the extractor hood must coincide with the line you have drawn on the wall. From inside the hood, mark the final points at which the hood has to be fixed to the wall. (to reach these points it will be necessary to remove activated carbon filter frame until the filter itself is replaced - see Fig. [. . . ] Insert the air pipe into the telescopic chimney support and fix it with four screws (Ø 2, 9 x 9, 5 mm). Fix the top part the telescopic outlet pipe to the relative support, using the two 3 mm dia x 9 mm screws R. Slide the bottom part of the telescopic outlet pipe downward until it rests in its housing on the top of the hood. For the best performance, we recommend using the low speeds in normal conditions and the high speeds in particular cases of strong odour and vapour concentration. -- We recommend starting up the hood a few minutes before cooking and keeping it running until all the odours have been eliminated. = Fan off = Fast speed switch (P+ the led on the bottom right side of the display flashes), This speed should be used when the concentration of cooking fumes or odours is particularly strong (for example when frying, cooking fish etc. The fast speed will run for about 5 minutes and then return to the speed previously set automatically (1, 2 or 3), or switch off if no speed was selected. To turn off the fast speed, before the end of the 5 minutes, press button and . Initially, only letter F will fbe displayed, then after the 3 seconds have passed, letter C will be displayed as well, indicating that the carbon filter saturation control system is active. To switch off the system, re-press the same two buttons: letter C appear on display and after 3 seconds letter it disappear and the device will be switched off. = Decrease fan speed button for reducing speed of motor from 3 down to speed 1. = Increase fan speed button for increasing speed of motor from 1 to 3. If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. [. . . ] The carbon filter extracts the odours present while cooking into the air flute It must be mounted on the inside of the cooker hood. Under normal use the carbon filter must be washed every two months, or each time the display flashes the letter C, by hand in a basin or in the dishwasher at 65%°C When washing it in the dishwasher it must be washed without any dishes in it using suitable Before mounting first remove the carbon filter and gently wash with a sponge to remove the excess water and dry in the oven at a constant temperature of maximum 100°C for 10 minutes. Remount the grease filter Once you have performed the maintenance and operation, press the buttons similtaneously for 3 seconds until the Letter C flashes on the display. [. . . ]