User manual ROSIERES RHB 9101 SP IN

[. . . ] It is also advisable to avoid any drastic changes in pipe cross-section (recommended diameter: 150 mm). For air evacuation to the outside, follow all the other instructions given on the "Warnings" sheet. [. . . ] Remove the grease filter by pushing the catch towards the rear of the hood and turning the filter outwards. 13) by inserting the two filter clips in the slots and turning the filter towards the inside of the hood. Fixing to the wall: for fixing to the wall refer to the instructions for the ducting version (see points 1, 2, 3), then continue with the instructions below. Fixing the telescopic flues: - Adjust the width of the support bracket (D) of the telescopic flue by means of the screws (E) as shown in Fig. - Then, by means of the screw anchors and screws (F) provided, fix the bracket to the ceiling in such a way that it is positioned along the axis with your hood. - Take the air baffle and fit a flexible pipe to it (125 mm diameter) locking it with a metal hose clamp (pipe and clamps are not provided). Insert the extension flues setting them on the hood; extend the upper flue to the ceiling and secure with the 2 screws H (Fig. Switch on the motor to the latest used speed and if pressed different times changes the speed in a cyclic way (1, 2, 3, 4, 1, 2. ) The speed set is visualized by the icon D5 and simultaneously the icon D8 switches on ( the speed of the rotational movement is proportional to the speed ). To switch off the motor, press the push button P2 for about 2 seconds (the set speed is memorized). It switches on when the grease filter must be cleaned (after about 30 hours of working). One time the grease filter is cleaned, to make the hours calculation start again, press the push button P4. [. . . ] 17) appears on the control display every 120 hours of hood operation to indicate that the charcoal filter needs to be replaced. 12): Turn the glass panel gripping it from the front part of the hood. [. . . ]