User manual ROSIERES RGM 9185 IN

[. . . ] - If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre. - This device must be connected to the supply network through either a plug fused 3A or hardwired to a 2 fase spur protected by 3A fuse. A) Do not check the status of the filters while the cooker hood is operating B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. C) Flambè cooking is prohibited underneath the cooker hood D) Avoid free flame, as it is damaging for the filters and a fire hazard E) Constantly check food frying to avoid that the overheated oil may become a fire hazard F) Disconnec t the elec trical plug prior to any maintenance. [. . . ] 3 - Fix the glass panel securely to the cooker hood body using the 4 sleeves C and 4 screws D as indicated. € Fixing to the wall Drill the holes A respecting the distances indicated (Fig. Fix the appliance to the wall and align it in horizontal position to the wall units. When the appliance has been adjusted, definitely fix the hood using the screws A (Fig. For the various installations use screws and screw anchors suited to the type of wall (e. If the screws and screw anchors are provided with the product, check that they are suitable for the type of wall on which the hood is to be fixed. • Fixing the decorative telescopic flue - extractor version warning!Before fixing the appliance in place, take the lower connector and use a pair of pliers to bend the tab inwards, as shown in figure 5, stage 1. Arrange the electrical power supply within the dimensions of the decorative flue. If your appliance must be installed as an extractor version, make sure an air exhaust hole has been prepared. 3) in such a way that it is in line with your hood and respecting the distance from the ceiling indicated in Fig. Connect the flange C to the air exhaust hole using a connection pipe (Fig. 5 - Stage 2), extract the upper flue up to the bracket and fix it with the screws B (Fig. Remove the charcoal filters already fitted to the appliance by turning them 90° anticlockwise (Fig. € Filtering version Install the hood and the two flues as described in the paragraph for installation of the hood in ducting version. Quency with which the appliance is used, the type of cooking performed and the regularity with which the anti-grease filters are cleaned. € Clean the cooker hood frequently, both inside and outside, using a cloth which has been dampened with denatured alcohol or neutral, non-abrasive liquid detergents. € The light on the cooker hood is designed for use during cooking and not for general room illumination. To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. 9A) mechanical the key symbols are explained below: A = LIGHT B = OFF C = SPEED I D = SPEED II E = SPEED III G = MOTOR WORKING indicator • Commands: (fig. 9 B) luminous the key symbols are explained below: A = LIGHT B = OFF C = SPEED I D = SPEED II E = SPEED III F = AUTOMATIC STOP TIMER - 15 minutes • By pressing key F for two seconds (with the hood switched off ) the “clean air” function is activated. This function switches the appliance on for ten minutes every hour at the first speed. [. . . ] The filters are not washable or re-usable and must be replaced at least once every four months. The active carbon filter saturation level depends on the fre- - 18 - - check that the plug has been inserted into the power socket correctly. If you cannot identify the cause of the operating anomaly: switch off the appliance (do not subject it to rough treatment) and contact the Assistance Service. It is important that you inform the Assistance Service of your product code and its serial number (a 16-character code which begins with the number 3); this can be found on the guarantee certificate or on the data plate located inside the appliance. [. . . ]