User manual ROSIERES RGM 91 IN

[. . . ] - This device must be connected to the supply network through either a plug fused 3A or hardwired to a 2 fase spur protected by 3A fuse. A) Do not check the status of the filters while the cooker hood is operating B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. [. . . ] If the screws and screw anchors are provided with the product, check that they are suitable for the type of wall on which the hood is to be fixed. Before fixing the appliance in place, take the lower connector and use a pair of pliers to bend the tab inwards, as shown in figure 5, stage 1. Arrange the electrical power supply within the dimensions of the decorative flue. If your appliance must be installed as an extractor version, make sure an air exhaust hole has been prepared. 3) in such a way that it is in line with your hood and respecting the distance from the ceiling indicated in Fig. 5 - Stage 2), extract the upper flue up to the bracket and fix it with the screws B (Fig. Remove the charcoal filters already fitted to the appliance by turning them 90° anticlockwise (Fig. Quency with which the appliance is used, the type of cooking performed and the regularity with which the anti-grease filters are cleaned. Clean the cooker hood frequently, both inside and outside, using a cloth which has been dampened with denatured alcohol or neutral, non-abrasive liquid detergents. The light on the cooker hood is designed for use during cooking and not for general room illumination. To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. 9A) mechanical the key symbols are explained below: A = LIGHT B = OFF C = SPEED I D = SPEED II E = SPEED III G = MOTOR WORKING indicator · commands: (fig. [. . . ] The filters are not washable or re-usable and must be replaced at least once every four months. - check that the plug has been inserted into the power socket correctly. [. . . ]