User manual ROSIERES RDM 917 IN

[. . . ] Before connecting the model to the electricity network: - Control the data plate (positioned inside the appliance) to ascertain that the voltage and power correspond to the network and the socket is suitable. - If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre. - This device must be connected to the supply network through either a plug fused 3A or hardwired to a 2 fase spur protected by 3A fuse. A) Do not check the status of the filters while the cooker hood is operating. [. . . ] Before proceeding with the assembly operations, for easier manoeuvrability of the appliance disengage the anti-grease filter by pulling handle B as indicated in Fig. If one owns a model with perimeter suction panel, before carrying out this operation, perform the following phases: - Open panel C as indicated in Fig. - If one owns the version with three A panels release them from the fixing pins by pulling outwards (Fig. During this disassembly and assembly operation ensure to hold the panel securely to prevent accidental falls. - Position the fixing template on the wall, making sure that the line coincides with the line previously made on the wall. - Align the appliance horizontally using the two levelling screws J (Fig. - Once the adjustment has been made, fasten the hood permanently using the screws K (Fig. - For easy accessibility to the motor unit in the case of assistance, after having levelled and fixed the appliance definitively, we recommend that the brackets are removed (Fig. - When carrying out the fixing operations, use only screws and screw anchors suited to the type of wall (e. - I f the screws and screw anchors are supplied with the appliance, make sure that they are suited to the type of wall to which the hood must be fixed. € Installation of models without decorative ducts: Extractor hood - Unclip the canopy M and remove the grille E (Fig. - Pass the power supply cable through the slot in the canopy M, as indicated in Fig. - Taking the grommet H, position it between the power cable and the slot (Fig. - Re-position the small cupola M paying attention that it is hitched perfectly to the fixing pins G (Fig. € Filtering version: - Unclip the canopy M and remove the grille E (Fig. - Pass the power supply cable through the slot in the canopy M, as indicated in Fig. - Taking the grommet H, position it between the power cable and the slot (Fig. - Fix the small cupola M and the grille E making sure that is it perfectly hooked on to the fastening pins G (Fig. € Optional accessories: This model may have decorative ducts as optional accessories - ask your retailer for information. Before installing decorative flues it is necessary to remove the small cupola M and loosen the 4 screws Q that lock the fastening pins G as shown in Fig. € Installation of models with decorative ducts: Extractor hood Make sure the electrical power supply is within the measurements of the decorative connector. Then fix it to the ceiling so that it is on the same axis as the hood using screws A and observing the distance from the ceiling shown in Fig. [. . . ] If key D is pressed the “clean air” function is deactivated and the motor moves to the 2nd speed straight away. (*) The “automatic stop timer” delays stopping of the hood, which will continue functioning for 15 minutes at the operating speed set at the time this function is activated. € Anti-grease/active charcoal filters saturation: - When the A key flashes with a 2 second frequency the antigrease filters must be washed. 5 second frequency the active carbon filters must be replaced or washed depending on the type of filter. [. . . ]