User manual ROSIERES RDM 1211

[. . . ] To facilitate installation, before starting remove the grease filters: press inward on the clamp at the handle and pull the filter downward (Fig. 5): making use of the appropriate drilling jig, apply the supplied blocks into the wall, and remember the distance between the hood and the cooktop must be at least 65 cm. [. . . ] Raise the upper flue as far as the ceiling and secure it to the bracket using the 2 screws (Fig. Also remember that charcoal filters must be used in the case of the filtering version; check to see whether such filters are already fitted; if necessary, proceed to fit as follows, depending on the model type purchased: - if the hood features round charcoal filters (Fig. 10), remove the two metal filter retainers (M) and position the charcoal filter inside the grease filter; fit the two filter retainers back on again to secure the charcoal filter. Depending on the model, the unit is equipped with the following controls: Controls shown in Fig. 12: Button A: Light switch; position 0: light off; position 1: light on. Button D: activates the motor (calling the last speed used) and increases the speed until reaching maximum. Button E: FILTER ALARM/TIMER RESET: when pressing the key during display of the filter alarm (motor off) it resets the hour counter. When pressing the key when the motor is running, the TIMER is activated and the hood will automatically be switched off after 5 minutes. When the LED is green (flashing) it indicates that the TIMER has been activated with the key E. After 120h of operation, the LED L2 turns RED and flashes; It indicates that the grease filters need to be cleaned and the charcoal filters replaced. After cleaning the grease filters (and/or replacing the charcoal filters), restart the hour counter (RESET) by pressing the key E during display of the filter alarm. 14: Button A: turns the lights on/off; every 30 hours of operation the corresponding pilot lamp (S) comes on to indicate that the grease filters must be cleaned; every 120 hours of operation the corresponding pilot lamp (S) flashes to indicate that the grease filters must be cleaned and the charcoal filter replaced. [. . . ] If the model purchased has the controls shown in Figure14, the charcoal filters must be replaced each time the light button (Fig. The motor used in this hood features a safety device (thermal cutout) that responds to temperature changes For accidental reasons or due to installation faults, this device could engage and automatically shut off the motor, thereby preventing serious damage to the equipment. [. . . ]