User manual ROSIERES RBI647

[. . . ] It is for this reason that the task should be undertaken by a professionally qualified person who will carry it out in accordance with the technical regulations in force. In the event that this advice is ignored and the installation is carried out by an unqualified person, the manufacturer declines all responsibility for any technical failure of the product whether or not it results in damage to goods or injury to individuals. The furniture in which your hob will be installed and all adjacent furniture, should be made from materials that can withstand high temperatures. In addition, all decorative laminates should be fixed with heat-resistant glue. [. . . ] ⷠAny queries regarding the power supply cord should be referred to After Sales Service or a qualified technician. ⷠI f the cable is damaged or to be replaced, the operation must be carried out the by sale agent with dedicated tools to avoid any accident. The socket shall be connected in compliance with the relevant standard, to a single-pole circuit breaker. You can not build the hob in above an oven with no fan, a dishwasher, fridge, freezer or washing machine. ⷠIt is essential that the induction hob is well ventilated and that the air intake and exit are not blocked. NB: For safety, the gap between the hob and any cupboard above it should be at least 760mm. Always use good quality cookware with perfectly flat and thick bases : using this type of cookware will prevent hot spots that cause food to stick. Ensure that the base of the pot or pan is dry : when filling pans with liquid or using one that has been stored in the refrigerator, ensure that the base of the pan is completely dry before placing it on the hob. Use pans whose diameter is wide enough to completely cover the surface unit : the size of the pan should be no smaller than the heating area. If it is slightly wider the energy will be used at its maximum efficiency. The following information will help you select the pans best adapted to obtain good results. ⷠOnly products, (creams and scrapers) specifically designed for glass ceramic surfaces should be used. ⷠAvoid spillages, as anything which falls on to the hob surface will quickly burn and will make cleaning more difficult. ⷠIt is advisable to keep away from the hob all substances which are liable to melt, such as plastic items, sugar, or sugar-based products. mAINTENANCE: - Place a few drops of the specialised cleaning product on the hob surface. - Rub any stubborn stains with a soft cloth or with slightly damp kitchen paper. - Wipe with a soft cloth or dry kitchen paper until the surface is clean. If there are still some stubborn stains: - Place a few more drops of specialised cleaning fluid on the surface. - Scrape with a scraper, holding it at an angle of 30° to the hob, until the stains disappear. - Wipe with a soft cloth or dry kitchen paper until the surface is clean. A FEW HINTS: Frequent cleaning leaves a protective layer which is essential to prevent scratches and wear. To remove marks left by water, use a few drops of white vinegar or lemon juice. [. . . ] A technician should verify the fitting in compliance with the recommendations, page 2. A scraper with a razor blade will not damage the surface, as long as it is kept at an angle of 30°. Never leave a scraper with a razor blade within the reach of children. Before calling out a Service Engineer please check the following: -- that the plug is correctly inserted and fused; If the fault cannot be identified: switch off the appliance -- do not tamper with it -- call the Aftercare Service Centre. [. . . ]