User manual ROSIERES RBI637

[. . . ] It is therefore advisable to ensure the room contains air taps able to ensure a steady flow of fresh air. Check the data label inside the appliance; if the symbol ( ) is printed, read the following: this appliance has such technical particulars that it belongs to class II insulation, therefore it must not be earthed. The following warning is valid in the United Kingdom only: as the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: ­ the wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black; ­ the wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. Check the data label inside the appliance; if the symbol ( ) is NOT printed, read the following: ATTENTION: This When making the electrical connections, check that the current socket has a ground connection. [. . . ] When making the electrical connections, check that the voltage values correspond to those indicated on the data plate inside the appliance itself. In case your appliance is not furnished with a non separating flexible cable and has no plug, or has not got any other device ensuring omnipolar disconnection from the electricity main, with a contact opening distance of at least 3 mm, such separating device ensuring disconnection from the main must be included in the fixed installation. Always switch off the electricity supply before carrying out any cleaning or servicing operations on the appliance. Particular care must be paid to the antigrease filters which must be periodically cleaned in relation to use (at least once every two months). Remove the antigrease filters and wash them either by hand or in the dishwasher using neutral detergent. To take off the anti-grease filters: at the handle, push the stop inwards and pull the filter downwards (Fig. Any fat deposits should be removed from the appliance periodically depending on amount of use (at least every 2 months). To clean painted appliances on the outside, use a cloth dipped in lukewarm water and neutral detergent. To clean steel, copper or brass appliances on the outside, it is always best to use specific products, following the instructions on the products themselves. To clean the inside of the appliance, use a cloth (or brush) dipped in denatured ethyl alcohol. Move the hood close to the bottom of the wall unit and then connect the two units by means of the 4 self-tapping screws supplied together with the appliance. 7 (optional): Take the two brackets (S) out of the accessory bag together with the 8 screws provided. Fit the brackets to the wall unit being careful to position these correctly; for this operation use the 4 longer screws. At this point, secure the appliance to the brackets using the 4 shorter screws. Ducting version and version with an External motor: connect the flange of the hood with the air venting hole made previously in the wall/ ceiling by means of an adequate tube. Make the electrical connection of the hood by means of the power supply cable. Filtering version: connect a proper pipe to the flange of the hood so that the air is sent outside the pensile and sent back into the room. Make the electrical connection of the hood by means of the power supply cable. Position L: the lights switch ON and the motor switch OFF either if the truck is open or closed; the motor is always OFF. When the switch is in M or T position, opening the truck, the motor starts working automatically at the selected speed. [. . . ] Opening slightly the truck, the motor works at the I speed; opening a bit more, the motor works at the II speed; opening totally the truck, the motor works at the III speed. In case the hood is a filtering version one, it is necessary to change the charcoal filters according to utilization about every six month. to remove the charcoal filter: ­ open the truck pulling it frontwards. ­ take off the anti-grease filter: where the handle is, pull the stop inwards and pull the filter downwards (Fig. [. . . ]