User manual ROSIERES PCDVB11CPN

[. . . ] The flush-mounted cook tops are designed for installation in work tops made of all kinds of material, providing they can withstand a temperature of 100°C, and are between 25 and 40 mm thick. If the cook top is installed in a position so that the side of a kitchen unit comes up against its left-hand or right-hand side, the distance between the vertical panel and the edge of the cook top must always be at least 150 mm. [. . . ] If you have to change the cord, the earthing (yellow / green) conductor must always be 10 mm longer than the line conductors. Use only rubber cable type H05RR-F; the cross-section of the wires must be 3x1. In the parts destined to come into contact with foodstuffs, this appliance is in accordance with the requirements of the EC directive 89/109 transposed in the Italian Legislative Decree N° 108 of 25/01/92. Important: Carefully clean the surface before using the barbecue for the first time, then switch the heating element (resistance) on for 5 minutes at the maximum temperature. This will prevent any food cooked on the barbecue from absorbing the smell the resistance will give off the first time it is switched on. The speed at which the food on the barbecue cooks depends on the position of the knob (1 to 12). When the knob is set to position 12, a slight click indicates the appliance has reached its maximum setting. The resistance quickly becomes red-hot, ready for the "grill-type" cooking method. Food will cook more evenly, also inside, if intermediate positions are used, rather than the resistance being very hot or simply warm. The container is filled with lava which absorbs any drops of oil or fat produced during cooking. It also accumulates the heat from the resistance in order to ensure food is grilled evenly. This cooking method is similar to the one which would be achieved by using charcoal. The manufacturers recommend preheating the lava for at least 10 minutes at a low temperature before grilling. Water can be poured into the container in place of the lava, to a level of at least 3cm. [. . . ] Before contacting the Technical Assistance: if the surface is not functioning correctly, check the plug has been correctly inserted in the socket. If you are unable to find the cause of the malfunction: turn the appliance off, do not tamper with it and contact the Technical Assistance Service. [. . . ]