User manual ROSIERES LV 412

[. . . ] The following information will help you to choose cookware which will give good performance. The sandwich bottom combines the benefits of stainless steel (appearance, durability and stability) with the advantages of aluminium or copper (heat conduction, even heat distribution). Aluminium residues sometimes appear as scratches on the hob, but can be removed if cleaned immediately. Bottom Good performance, but copper may leave residues which can appear as scratches. [. . . ] To switch off a surface unit, turn the corresponding knob back on the "0" setting. The V 39 V ceramic hob has a surface unit with an extension, allowing the use of large sized cooking vessels. To switch on the 1500 W surface unit, turn the knob right to the requested setting. To switch on the surface unit with extension, turn the knob right, pass over the setting 12, force the spring till the stop, then come back on the requested setting. By setting the knob on "0", the surface unit will totally stop. When you become familiar with using your hob you will be able to work out settings to suit yourself. Slow Moderate Medium High Very high Slow cooking, bechamel, stews, rice in milk, poached eggs . MAINTENANCE OF GLASS CERAMIC HOBS ____________________________________________________________________________ Before carrying out any maintenance work on the hob, let it cool down. Rub any stubborn stains with a soft cloth or with slightly damp kitchen paper. Wipe with a soft cloth or dry kitchen paper until the surface is clean. Scrape with a scraper, holding it at an angle of 30° to the hob, until the stains disappear. To ensure proper ventilation around the hob, allow at least 1 cm between the underside of the hob and the cabinet, and a 10 x 10 cm opening as illustrated. When placing the hob, make sure that the joint (fitted with the hob) between the surrounding edge of the appliance and the worktop is properly sealed and that spillages cannot leak into any gap. ____________________________________________________________________________________ INSTALLATION - ELECTRICAL CONNECTION _______________________________________________________________________________ "The installation must be in conformity with standard directives". Rosières declines all responsabiity for any damage that may be caused by unsuitable or unreasonable use. Connection to the power supply should be made through an earthed, three-pin wall socket or an omnipole cut-out switch with an opening gap of at least 3 mm. the electrical installation should be protected by a fuse , properly earthed , and includes wires of a sufficient section to supply the product correctly. A power cord is not supplied with the appliance, but the hob is equipped with a terminal block which enables you to choose the correct connection for the particular power supply by placing shunts according to technical data page 25. the location of phases , neutral and earthed on the electrical outlet , . The yellow/green wire of the power supply cable must be connected to the earth of both power supply and appliance terminals. attention : Always check the continuity of the connection to the installation before any electrical operation. Rosières cannot be held responsible for any accidents resulting from the use of an appliance which is not connected to earth, or with a faulty earth connection continuity. [. . . ] - Strip the end of each conductor of the supplying cord, on a 10 mm length, by taking in account the requested length of the cord for the connection on the terminl block. So, according to your installation, and with the help of shunt bars, (see drawing) fix the conductors as shown on the chart, page 25. Do not forget to fix the earth wire yellow/green on the earth terminal. ___________________________________________________________________________ GUARANTEE __________________________________________________________________________________ The guarantee contract consists simply and solely in exchanging or replacing any part considered by us to be defective, or repairing it after examination by our Technical Assistance, to the exclusion of all other indemnities of whatever kind. [. . . ]