User manual ROSIERES KIT CREATIS INOX INSTALLATION

[. . . ] The Domino cook tops are fixed to the work top using the kit of brackets provided. Check the details given on the nameplate situated on the underside of the cook top, then make sure that the rated mains voltage and power available are suitable for its operation. The manufacturer will accept no liability for any personal injury or damage to property deriving from failure to comply with this requirement. For models without a plug, fit a standard plug capable of withstanding the specified load on the power cord. [. . . ] For models without a plug, fit a standard plug capable of withstanding the specified load on the power cord. If you prefer to make a fixed connection to the mains, insert an all-pole circuit breaker with a breaking gap of at least 3 mm between the cook top and the mains. To connect the cook top power cord, loosen and remove the cover on the terminal block in order to access the contacts inside. Make the connection, blocking the cord in place with the cable clamp provided and then close the terminal block cover again immediately. If you have to change the cord, the earthing (yellow / green) conductor must always be 10 mm longer than the line conductors. Use only rubber cable type H05RR-F; the cross-section of the wires must be 3x1. In the parts destined to come into contact with foodstuffs, this appliance is in accordance with the requirements of the EC directive 89/109 transposed in the Italian Legislative Decree N° 108 of 25/01/92. Important: Carefully clean the surface before using the deep-fat fryer for the first time. Wash the oil container and basket using hot water and washing-up liquid. After cleaning the appliance thoroughly, switch the heating element (resistance) on for 5 minutes at the maximum temperature without filling the container with oil. Remove any food deposits from the container using a sponge or kitchen towel. The filtered oil can be kept in the stainless steel container inside the deep-fat fryer. However, if the fryer is not used for long periods of time, the oil will keep better in a closed container. Oil used for frying fish should be kept separate from the oil used for frying other foods. Do not drop hard objects on the glass surfaces as under some conditions they are sensitive to mechanical loads. If the glass-ceramic surface is accidentally broken or cracked, switch the appliance off immediately and contact the Customer Service Department. Ensure that cables and plugs of other domestic appliances inserted in sockets positioned near the deep-fat fryer do not come into direct contact with hot cooking surfaces. Do not, under any circumstances, clean the surface using steam cleaning appliances or similar. Even very small residues of food left on the surface will burn the next time the appliance is used. The stainless steel components of the appliance must be cleaned using non-abrasive, non-corrosive products. [. . . ] Even very small residues of food left on the surface will burn the next time the appliance is used. The stainless steel components of the appliance must be cleaned using non-abrasive, non-corrosive products. Do not use oven-cleaning products to clean the appliance as they are corrosive. Surface dirt can be removed using either a damp cloth or hot sodium carbonate. [. . . ]