User manual ROSIERES GS 41

[. . . ] If the plug is not accessible once it has been inserted in the socket, it will however be necessary to fit an approved bipolar switch with a minimum contact opening of no less than 3mm. Appliance without plug Fit an approved plug or an approved bipolar switch with a minimum contact opening of not less than 3mm. Exhaust mode (S) Vapours are extracted outside through an exhausting pipe that is affixed to the connection ring above the hood. [. . . ] Exhaust mode (S) Vapours are extracted outside through an exhausting pipe that is affixed to the connection ring above the hood. diameter of the exhausting pipe must be equal to that of the connection ring. In the horizontal runs the duct must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. Filter version (K) The air is filtered through a carbon filter (for its installation see paragraph "Carbon filter") and recirculated into the room through the grating on the lower side of the chimney. If the hood is not supplied with carbon filter, then it must be ordered and mounted. This version is used when there is no exhaust duct for venting outdoors or when it is impossible to install one. The use of an unprotected flame is dangerous for the filters and could cause fires. ­ The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. ­ When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate air supply. When installed, the distance between extractor and hob gas burners or electric plates must be not less than 65 cm providing the total hob output does not exceed 11kw. For each kw in addiction, the distance between extractor and hob gas burners must be increased of 10 cm. Electric connection Before completing any connection make sure the house voltage corresponds with the voltage indicated on the label affixed inside Metal grease filter (2 or 3 pieces) The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. Remove the filter using the handles designed for this purpose by pulling the filter backwards and then downwards (Fig. Let the filter dry without damaging it before putting it back into place. [. . . ] Electric connection Before completing any connection make sure the house voltage corresponds with the voltage indicated on the label affixed inside Metal grease filter (2 or 3 pieces) The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. Remove the filter using the handles designed for this purpose by pulling the filter backwards and then downwards (Fig. Let the filter dry without damaging it before putting it back into place. [. . . ]