User manual ROSIERES GS 40

[. . . ] The company shall not be liable if the instructions provided in this document are not complied with. The parts of this appliance that may come into contact with foodstuffs comply with the provisions of EEC Directive 89/109. This appliances complies with Directives 89/336/EEC, 73/23/EEC and following changes. If the assistance of the manufacturer is required to rectify faults arising from incorrect installation, this assistance is not covered by the guarantee. [. . . ] Settings: quantity/weight, temperature, programming cooking and end of cooking time - Regulated by turning the button towards "-" or "+" To confirm settings: press the button Weight of the meat * PRELIMINARY CLEANING - clean the oven before using for the first time: . Wash all accessories and wipe inside the oven with a solution of hot water and washing up liquid. Set the empty oven to the maximum temperature and leave on for about 1 hour, this will remove any lingering smells of newness. THINGS TO REMEMBER Confirmation of operation: modification must be confirmed by pressing the central button, during 1 second. Stopping the oven: this may be necessary if you have input an incorrect instruction. Child safety device: To lock the oven controls, select the child safety device. refer to the section entitled "Programming - The child safety device". The cooling fan: this protects the control panel and electronics from heat damage. It begins and then stops automatically even when the oven is switched off. Oven lighting: By turning to the light symbol, you can switch on the oven light when it is not in use. When the oven is in use, the light stays on during all of the oven functions and when the door is opened. The temperature display is fixed but can be modified during the cooking cycle. The indicator light flashes until the selected temperature has been reached. An audible signal sounds at the end of this operation and the indicator light becomes fixed. 3- A cooking time and an end of cooking time can be programmed by turning the programme selector knob to "cooking time" or "end of cooking time". When you have done this, do not forget to turn the programme selector knob back to to confirm the new setting. For more details about programming, refer to the chapter entitled PROGRAMMING. 4- At the end of the cooking cycle, turn the function selector knob back to . The indicator flashes again, it will remain also turned on after having extinguished the oven and it will estinguish when the inside temperature of the oven is sufficiently low. RECIPE MODE according to the oven model the recipes are described on the table below. For each mode of cooking a temperature is pre-programmed according to the weight, it is not adjustable. An audible signal sounds for 15 seconds to tell you the cycle has ended and the "cooking time" and STOP symbols flash. [. . . ] Before carrying out a Pyrolytic cycle : - Remove all accessories from the oven : they cannot withstand the high temperatures and would be damaged by pyrolytic temperatures. - Remove any large spillages or stains as it would take too long to destroy them. Also excessively large amounts of grease could ignite when subject to the very high temperatures of the Pyrolyticcycle. 2- By using the central button select the required Pyrolytic mode, according the degree of staining : This function is essential, especially when children are around. [. . . ]