User manual ROSIERES F 142

[. . . ] IMPORTANT: So as not to damage your product, during installation USE ONLY THE SCREWS PROVIDED. To compensate possible depth voids between the appliance and the wall, a plastic SPACING BAR to be fixed at the back of the appliance by means of the three screws A is included (Fig. The following operations are essential for assembly: ­ Install the wiring system ­ Prepare the air venting hole if your applian-ce is to be installed in the Ducting version. [. . . ] 5: Make the 4 necessary fixing holes in the bottom of the cupboard and cut the air venting hole. Move the hood close to the bottom of the wall unit and then connect the two units by means of the 4 self-tapping screws supplied together with the appliance. 6: Take the two brackets (S) out of the accessory bag together with the 4 screws provided. Fit the brackets to the wall unit being careful to position these correctly; for this operation use the 4 longer screws. At this point, adjust the angle of the appliance with the 4 screws (B) and fasten the appliance to the brackets using the 2 shorter screws (C). Ducting version : connect the flange of the hood with the air venting hole made previously in the wall/ceiling by means of an adequate tube. Assemble the anti-grease grille with the hood, inserting it obliquely (making the front side go upwards). Button E: drives the motor in fourth speed (the corresponding pilot lamp comes on). Provision has been made to delay switching off of the hood to allow completion of ambient air purification. Starting from 2nd speed, when pressing the current operating speed button (pilot lamp on), switching off will be delayed for 5'. Pay special attention to the grease filters: the metal grease filters must be cleaned approximately once every 30 hours of operation (when the light button lamp comes on) - Fig. 3): this is carried out by pushing the relative catch inwards and turning it downwards until it disengages from the supports. Once the cleaned filters are reinstalled, to reset the counter hold the light button pressed down for about 1" (Fig. 9): P1 Press to switch off LIGHTS P2 Press to switch on LIGHTS P3 When pressed with motor OFF, nothing occurs When pressed with motor RUNNING, drops speed to 1st level. [. . . ] Once the cleaned filters are reinstalled, to reset the counter hold the light button pressed down for about 1" (Fig. 9): P1 Press to switch off LIGHTS P2 Press to switch on LIGHTS P3 When pressed with motor OFF, nothing occurs When pressed with motor RUNNING, drops speed to 1st level. When kept pressed for 2' with motor RUNNING, switches off motor and stores speed P4 When pressed with motor OFF, it starts the motor at the speed stored during switch-off or first speed When pressed with the motor RUNNING, it increases speed L1 these indicate the current speed (green) P5 Resets the filter Reset count with motor OFF with motor RUNNING it triggers TIMER 5' L2 This indicates: 1) with motor OFF, the FILTER RESET IN RED, (30 hours Led Steady, 120 hour flashing) 2) In FLASHING GREEN the 5' TIMER Replacing the charcoal filter: When using the filtering version of the appliance, the actived carbon filters must be changed according to use (Fig. [. . . ]