User manual ROSIERES F 132

[. . . ] Adjust the horizontal position moving the hood to the right or left so that it is aligned with the wall units. If you also need to adjust the hood in height, operate on the adjusting screws (B) provided. When adjustment has been completed, without removing the hood, mark the other 6 holes to be drilled (C) in the wall. Then use the 6 screw anchors and the 6 screws provided for final fixing. [. . . ] - Use a flexible pipe and lock it to the air vent of the hood with a metal hose clamp - Fig. - For exhaust hoods, turn the upper flue over so that the air exhaust grid is in the lower section (Fig. Insert the extension flues setting them on the hood; extend the upper flue to the ceiling and secure with the 2 screws (H) - Fig. INSTALLATION IN FILTERING VERSION: Prepare the power supply within the telescopic flues (for the electrical connection, follow all the other instructions on the "Warnings" sheet). Fixing to the wall: for fixing to the wall refer to the instructions for the ducting version (see points 2, 3, 4), then continue with the instructions below. fixing the telescopic flues: - Assemble the tube support using a 4 screws kit (Fig. 9); - Then, by means of the screw anchors and screws (F) provided, fix the bracket to the ceiling in such a way that it is positioned along the axis with your hood (Fig. ­ Take the air baffle and fit a flexible pipe to it (125 mm diameter) locking it with a metal hose clamp (pipe and clamps are not provided). Insert the extension flues setting them on the hood; extend the upper flue to the ceiling and secure with the 2 screws H (Fig. - Install the charcoal filter fitting the two filter clips in their housings (Fig. Depending on the model, the unit is equipped with the following controls: CONTROLS shown in Fig. - signals the filter alarm (with motor off) by displaying the central segment for 30". FILTER ALARM: Displayed for 30" when the motor is off: After 30h of operation the central segment lights up on the display; It indicates that the grease filters need to be cleaned. After 120h of operation, the central segment flashes on the display; It indicates that the grease filters need to be cleaned and the charcoal filters replaced. After cleaning the grease filters (and/or replacing the charcoal filters), restart the hour counter (RESET) by pressing the key C during display of the filter alarm. GAS SENSOR SENSITIVITY: The sensitivity of the sensor can be modified to suit your requirements. The running speed and not the letter "A" must appear on the display); If not, press the key E. By means of the buttons C(-) and D(+) the desired sensitivity is set Store the "new" sensitivity by pressing the key E. B) Switches on the lights calling the last level of luminous intensity set. D) Drives the motor (calling the last speed used) and increases the speed until reaching maximum. When the motor speed is changed, the running speed is displayed flashing times, and then the letter "A" reappears. - signals the filter alarm (with motor off) by displaying the central segment for 30". [. . . ] - signals the filter alarm (with motor off) by displaying the central segment for 30". FILTER ALARM: Displayed for 30" when the motor is off: After 30h of operation, the letter "F" appears on the display; It indicates that the grease filters need to be cleaned. After 120h of operation, the letter "F" flashes on the display; It indicates that the grease filters need to be cleaned and the charcoal filters replaced. After cleaning the grease filters (and/or replacing the charcoal filters), restart the hour counter (RESET) by pressing the key C during display of the filter alarm. [. . . ]