User manual ROSIERES 5265

[. . . ] For air evacuation to the outside, follow all the other instructions given on the "Warnings" sheet. Prepare the power supply within the telescopic chimney (for the electrical connection, follow all the other instructions on the "Warnings" sheet). Fixing to the wall: Draw a line on the wall in vertical line with your hob. [. . . ] Mark the first 2 holes to be drilled in the wall, respecting the distances indicated in Fig. As already specified on the "Warnings" sheet, bear in mind that the distance between the lower edge of the hood and the hob must be min. Fix the metal bracket (A) to the wall using the 2 holes just drilled (Fig. Use the 2 cut-out triangles on the bracket to position it exactly along the vertical axis of the hood. Adjust the horizontal position moving the hood to the right or left so that it is aligned with the wall units. If you also need to adjust the hood in height, operate on the adjusting screws (B) provided. When adjustment has been completed, without removing the hood, mark the other 4 holes to be drilled (C) in the wall. - Install the charcoal filter fitting the two filter clips in their housings (Fig. D) Activates the motor (calling the last speed used) and increases the speed until reaching maximum. E) FILTER ALARM/TIMER RESET: when pressing the key during display of the filter alarm (motor off) it resets the hour counter. When pressing the key when the motor is running, the TIMER is activated and the hood will automatically be switched off after 5 minutes. When the LED is green (flashing) it indicates that the TIMER has been activated with the key E. After 120h of operation, the LED L2 turns RED and flashes; It indicates that the grease filters need to be cleaned and the charcoal filters replaced. After cleaning the grease filters (and/or replacing the charcoal filters), restart the hour counter (RESET) by pressing the key E during display of the filter alarm. [. . . ] After 120h of operation, the LED L2 turns RED and flashes; It indicates that the grease filters need to be cleaned and the charcoal filters replaced. After cleaning the grease filters (and/or replacing the charcoal filters), restart the hour counter (RESET) by pressing the key E during display of the filter alarm. Grease filters: special attention must be given to the grease filters which must be periodically cleaned, whenever the grease filter alarm trips. [. . . ]