User manual ROSIERES 1401

[. . . ] The furniture in which your hob will be installed and all adjacent furniture, should be made from materials that can withstand high temperatures. In addition, all decorative laminates should be fixed with heat-resistant glue. To install it: - turn the hob upside down, with the glass surface facing downwards. - make sure that it is correctly fitted to avoid any leakage into the supporting cabinet. [. . . ] Any queries regarding the power supply cord should be referred to After Sales Service or a qualified technician. The hob is fitted with a power supply cord which allows it to be connected only to a power supply of 220-240 V between phases or between phase and neutral : - Connect to a socket, to choose the correct fuse, you must refer on the table. THE CHOICE OF COOKWARE - The following information will help you to choose cookware which will give good performance. The sandwich base combines the benefits of stainless steel (appearance, durability and stability) with the advantages of aluminium or copper (heat conduction, even heat distribution). Aluminium residues sometimes appear as scratches on the hob, but can be removed if cleaned immediately. Good performance, but copper may leave residues which can appear as scratches. the residues can be removed , as long as the hob is cleaned immediately. Shunting : make a bridge with shunt Hilight zone : a metallic conductor strip is spread uniformly over the whole surface unit. It is effective within 3 seconds and is suitable for steady, homogeneous and also sustained cooking. The glass-ceramic hob benefits from greater heat output which is generated by the hilight cooking zones thereby accelerating the cooking process. Modifications to the design of the hob have not affected the capacity of the glass to withstand high temperatures, but they have improved controllability. - Wipe with a soft cloth or dry kitchen paper until the surface is clean. A FEW HINTS: Frequent cleaning leaves a protective layer which is essential to prevent scratches and wear. To remove marks left by water, use a few drops of white vinegar or lemon juice. Then wipe with absorbent paper and a few drops of specialised cleaning fluid. The glass ceramic surface will withstand scraping from flatbottomed cooking vessels, however, it is always better to lift them when moving them from one zone to another. The cooking zones do not simmer or only fry gently · only use flat-bottomed pans. If light is visible between the pan and the hob, the zone is not transmitting heat correctly. The pan bottom should fully cover the diameter of the selected zone. Only use flatbottomed utensils, that are heavy and have a diameter at least the same as the cooking zone. small scratches or abrasions on the hob's glass surface · Incorrect cleaning or rough-bottomed pans are used; particles like grains of sand or salt get between the hob and the bottom of the pan. Refer to the "CLEANING" section; make sure that pan bottoms are clean before use and only use smooth bottomed pans. [. . . ] Before calling out a Service Engineer please check the following: -- that the plug is correctly inserted and fused; If the fault cannot be identified switch off the appliance -- do not tamper with it -- call the Aftercare Service Centre. The appliance is supplied with a guarantee certificate that ensures that it will be repaired free of charge at the Service Centre. A scraper with a razor blade will not damage the surface, as long as it is kept at an angle of 30°. Never leave a scraper with a razor blade within the reach of children. [. . . ]