User manual ROSE DISPLAYS SUPERSNAP WITH ROD, CABLE CLIP AND BALL CHAIN

[. . . ] SuperSnapTM with Rod Connector Parts Instruction Sheet Cable Clip 06-5050 SuperSnap 12S300 End Caps 06-5475 6" Rod 97-0304-06 Ball Chains 96-0302P Instructions for assembly Step 1 Insert single ball of ball chain into inner channel of Cable Clip. 1 Align one round end of cable clip with top channel of the rail and insert. [. . . ] Part #02INSSuperSnapRodCCBC 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com Incept-11. 13. 02 SuperSnapTM with Rod Connector Parts Instruction Sheet Cable Clip 06-5050 SuperSnap 12S300 End Caps 06-5475 6" Rod 97-0304-06 Ball Chains 96-0302P Instructions for assembly (continued) Step 4 Snap all sections of the SuperSnap open. 7 Note: It is easier to open and close the SuperSnap by starting at one end and working your way down the holder. Step 5 Insert poster (top and bottom) into all sections of SuperSnap. 8 Open all holders Figure 7 Figure 8 Step 6 To close, snap the SuperSnap shut. Finished Look Figure 9 Figure 10 Important note: Please save and reuse the SuperSnap, End Caps and CableClips for future projects. Finished Look Page 2 of 2 The SuperSnapTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSSuperSnapRodCCBC 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com Incept-11. 13. 02 SuperSnapTM with Rod Connector Parts Instruction Sheet Cable Clip 06-5050 SuperSnap 12S300 End Caps 06-5475 6" Rod 97-0304-06 Ball Chains 96-0302P Instructions for assembly Step 1 Insert single ball of ball chain into inner channel of Cable Clip. 1 Align one round end of cable clip with top channel of the rail and insert. Then press down on the other round end of the cable clip and slide into rail by pushing on the clip. 2 Note: Be sure to push on the cable clip in order to slide the ball chain into place. Do not pull on, or push against, the ball chain as this will cause it to bind in the channel. 3 Figure 1 Figure 2 Figure 3 Step 2 Push rod halfway into clip rail of one SuperSnap. 4 Figure 4 Step 3 Insert rod into top clip rail of second SuperSnap until both holders meet. [. . . ] Finished Look Figure 9 Figure 10 Important note: Please save and reuse the SuperSnap, End Caps and CableClips for future projects. Finished Look Page 2 of 2 The SuperSnapTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. [. . . ]