User manual ROSE DISPLAYS SUPERSNAP WITH ANOCONNECTORS, CABLE CLIP, AND BALL CHAIN

[. . . ] SuperSnapTM with AnoConnector Parts Instruction Sheet 6" Rod 97-0304-06 CableClip 06-5050 SuperSnap 12S300 End Caps 06-5475 AnoConnector 06-2930 Ball Chains 96-0302P Instructions for assembly Step 1 Insert single ball of ball chain into inner channel of Cable Clip. 1 Align one round end of cable clip with top channel of the rail and insert. [. . . ] Part #02INSSuperSnapAnoConnectorCCBC 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com Incept-11. 13. 02 SuperSnapTM with AnoConnector Parts Instruction Sheet 6" Rod 97-0304-06 CableClip 06-5050 SuperSnap 12S300 End Caps 06-5475 AnoConnector 06-2930 Ball Chains 96-0302P Instructions for assembly (continued) Step 5 Snap all sections of the SuperSnap open. 7 Note: It is easier to open and close the SuperSnap by starting at one end and working your way down the holder. Step 6 Insert graphic into one section of SuperSnap (top and bottom). 8 Open all holders Figure 7 Figure 8 Step 7 To close, snap the SuperSnap shut. Repeat steps 5-7 for hanging additional graphics. Insert posters Figure 9 Figure 10 Step 9 Push end caps into place. Finished Look Important note: Please save and reuse the SuperSnap, End Caps and CableClips for future projects. Finished Look Page 2 of 2 The SuperSnapTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSSuperSnapAnoConnectorCCBC 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com Incept-11. 13. 02 SuperSnapTM with AnoConnector Parts Instruction Sheet 6" Rod 97-0304-06 CableClip 06-5050 SuperSnap 12S300 End Caps 06-5475 AnoConnector 06-2930 Ball Chains 96-0302P Instructions for assembly Step 1 Insert single ball of ball chain into inner channel of Cable Clip. 1 Align one round end of cable clip with top channel of the rail and insert. Then press down on the other round end of the cable clip and slide into rail by pushing on the clip. 2 Note: Be sure to push on the cable clip in order to slide the ball chain into place. Do not pull on, or push against, the ball chain as this will cause it to bind in the channel. 3 Figure 1 Figure 2 Figure 3 Figure 4 Step 2 Insert AnoConnector into rail of one SuperSnap. 4 Step 3 Insert threaded rod halfway into clip rail of the same SuperSnap. 5 Step 4 Push the second piece of SuperSnap onto both AnoConnector and the threaded rod. [. . . ] Finished Look Important note: Please save and reuse the SuperSnap, End Caps and CableClips for future projects. Finished Look Page 2 of 2 The SuperSnapTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. [. . . ]