User manual ROBLIN VIZION INOX 900 SANS CHEMINEE ET SANS MOTEUR DIMENSIONS

[. . . ] Be sure to insulate any loose unconnected leads with electrical tape for safety. Notes on the power supply lead (yellow) When connecting this unit in combination with other stereo components, the connected car circuit's rating must be higher than the sum of each component's fuse. When no car circuits are rated high enough, connect the unit directly to the battery. The bracket and the protection collar are attached to the unit before shipping. [. . . ] Before mounting the unit, use the release keys to remove the bracket from the unit. for details , see "Removing the protection collar and the bracket ()" on the reverse side of the sheet. Keep the release keys for future use as they are also necessary if you remove the unit from your car. Note Before installing, make sure that the catches on both sides of the bracket are bent inwards 2 mm (3/32 in). If the catches are straight or bent outwards, the unit will not be installed securely and may spring out. Notes (-A) Be sure to connect the ground (earth) lead before connecting the amplifier. To AMP REMOTE IN of an optional power To the interface cable of a car telephone warning If you have a power antenna (aerial) without a relay box, connecting this unit with the supplied power supply lead may damage the antenna (aerial). Notes on the control and power supply leads The power antenna (aerial) control lead (blue) supplies +12 V DC when you turn on the tuner, or when you activate the AF (Alternative Frequency) or TA (Traffic Announcement) function. When your car has built-in FM/MW/LW antenna (aerial) in the rear/ side glass, connect the power antenna (aerial) control lead (blue) or the accessory power supply lead (red) to the power terminal of the existing antenna (aerial) booster. Before installing the unit, remove the protection collar and the bracket from the unit. Insert both release keys together between the unit and the bracket until they click. Make sure that the 4 catches on the protection collar are properly engaged in the slots of the unit (-3). Yellow Gelb Jaune Giallo Geel Yellow Gelb Jaune Giallo Geel continuous power supply permanente Stromversorgung alimentation continue alimentazione continua continue voeding Red Rot Rouge Rosso Rood Yellow Gelb Jaune Giallo Geel switched power supply geschaltete Stromversorgung alimentation commutée alimentazione commutata geschakelde voeding How to detach and attach the front panel Before installing the unit, detach the front panel. Engage part of the front panel with part of the unit, as illustrated, and push the left side into position until it clicks. To capture your voice during handsfree calling, you need to install the microphone (supplied). cautions Keep the microphone away from extremely high temperatures and humidity. It is extremely dangerous if the cord becomes wound around the steering column or gearstick. If airbags or any other shock-absorbing equipment is in your car, contact the store where you purchased this unit, or the car dealer, before installation. [. . . ] If airbags or any other shock-absorbing equipment is in your car, contact the store where you purchased this unit, or the car dealer, before installation. Yellow Gelb Jaune Giallo Geel Yellow Gelb Jaune Giallo Geel switched power supply geschaltete Stromversorgung alimentation commutée alimentazione commutata geschakelde voeding Red Rot Rouge Rosso Rood Yellow Gelb Jaune Giallo Geel continuous power supply permanente Stromversorgung alimentation continue alimentazione continua continue voeding Install clips (not supplied) and adjust the length and position of the cord so that it does not obstruct your driving. Install the microphone a on the clip b , then place the cord along the groove of the clip b . Install a clip (not supplied) and adjust the length and position of the cord so that it does not obstruct your driving. [. . . ]