User manual ROBLIN LIDO DESIGN 900 DIMENSIONS

[. . . ] - Do not flambé food underneath the hood (the flames drawn in could damage the filters or create a fire risk). The hood is fitted with a control box behind the opening, containing 3 controlside (fig. - Slide "M" is used to start or stop the fan, confirmed by a power on indicator. [. . . ] A contactor above the control box cuts off the power as soon as the auvent is fully closed, but functions previously regulated with the slides are maintained. Before carrying out any work (cleaning changing filters - lighting), switch the appliance off by pulling the plug out if you can reach it, or by switching the circuit breaker off. The metal grease filter should be cleaned every two months with normal usage and can be cleaned in a dishwasher or by hand using a mild detergent or liquid soap. - This filter cannot be cleaned, and therefore must be replaced at a frequency which depends on the frequency of use (about twice per year). Use lukewarm water only, to which a non-aggressive cleaning liquid is added. If you request assistance from your After Sales Service, you should inform them of the characteristics stated on the identification plate close to the motor in your hood (model - type - serial number). This is why our guarantee is applicable exclusively and soley to appliances which have been installed and connected by yourself, in accordance with the requirements of ordinances in force. - The minimum distance between the top of the cooker hob and the bottom of the hood shall be 650 mm. - If your cooking appliance has a cover, check that it can be lifted without hindrance. - Connect the hood to an individual or collective duct (unused flue) using pipes and connection pieces made of uninflammable material. - When the evacuation version hood is used, it must not hinder existing ventilation or extraction, and must be in accordance with Unified Technical Document DTU n° 61-1. - Connection fittings must be made in accordance with standard practice and respect safety conditions, and under no circumstances shall the evacuation duct discharge into the attic. - In this case, it is recommended that the telescopic suction cup reference AH 4009 F1 with built in non-return valve be used (fig. - This square suction cup was specially designed for hoods and can be built into any outside wall between 23 and 43 cm thick. - Outside shutters prevent wind and rain from entering and a raised edge (water spray) on the lower edge prevents dirtying the facade. - The built in non-return valve prevents return of cold air into the kitchen during winter. 8 Special instructions provided with the suction cup give all necessary additional information. - Put the adjustment lever to the recycling position (down) and after installing the active carbon filter (as described in the installation part of these instructions and in accordance with the instructions attached to the recycling kit) the recycled air is discharged through the louvers at the top of the hood facade. [. . . ] - Put the adjustment lever to the recycling position (down) and after installing the active carbon filter (as described in the installation part of these instructions and in accordance with the instructions attached to the recycling kit) the recycled air is discharged through the louvers at the top of the hood facade. - In this case the hood must be drawn fully down to completely free the facade louvers. - Lift the auvent by its lower part and insert the two upper guide-slides in their respective housings. [. . . ]