User manual ROBLIN LAGOON 900 DIMENSIONS

[. . . ] Mark a reference point as indicated at 116 mm from the vertical reference line and 306 mm above the horizontal reference line. Insert the two screws 12a (4, 2 x 44, 4) supplied in the hood body fixing holes, leaving a gap of 5-6 mm between the wall and the head of the screw. Before attaching the hood body, tighten the two screws Vr located on the hood body mounting points. [. . . ] Before attaching the hood body, tighten the two screws Vr located on the hood body mounting points. DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120mm, the choice of which is left to the installer. Connect the air outlet connection 15 to the hood body outlet using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Slightly widen the two sides of the upper flue and hook them behind the brackets 7. Make sure that the outlet of the extensions pieces is aligned with the chimney outlets. lower exhaust flue · Slightly widen the two sides of the flue and hook them between the upper flue and the wall, making sure that they are well seated. The alarm signal will only light up when the extractor motor is switched on. Disconnect the Hood using the Main switch or the double-pole switch on the mains power supply. All five LEDs are turned on · Within 3 seconds press T1 until LEDs T1 and T4 flash in confirmation: LED flashes twice - Activated charcoal filter saturation alarm ENABLED LED flashes once - Activated charcoal filter saturation alarm DISABLED Switch off the lights and extractor motor. Press button T3 for at least 3 seconds, until the leds start to flash. Fit the new filter by hooking it into its seating · Remove the snap-on lamp cover by levering it from under the metal ring, supporting it with one hand. Replace the lamp with a new one of the same type, making sure that you insert the two pins properly into the housings on the lamp holder. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. [. . . ] Fit the new filter by hooking it into its seating · Remove the snap-on lamp cover by levering it from under the metal ring, supporting it with one hand. Replace the lamp with a new one of the same type, making sure that you insert the two pins properly into the housings on the lamp holder. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. [. . . ]