User manual ROBLIN GRAPHIC MURALE 900

[. . . ] ⷠCheck that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. If the extractor is used in conjunction with non-electrical appliances (e. [. . . ] 1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the centre (notch) with the vertical reference line. 1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied), aligning the centre (notch) with the vertical line. DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe, the choice of which is left to the installer. Fix the directional grille 8 on the recirculation air outlet using the 2 screws 12d (2, 9 x 9, 5) provided. The chimney can only be installed with exhausting hood · Slightly widen the two sides of the upper flue and hook them behind the brackets 7. Slightly widen the two sides of the flue and hook them between the upper flue and the wall, making sure that they are well seated. ⷠFix the lower part laterally to the hood body using the 2 screws 12c (2, 9 x 6, 5) supplied. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. The hood can be switched on pushing directly onto the requested speed without firstly having to select 0/1 button. It allows a T3 suction level of 100 m3/h with a noise level of just 28dB(A). Can be enabled at any speed and is disabled by pressing the button briefly. The function becomes active when the button is pushed for about 2 seconds. [. . . ] ⷠPress button T3 for at least 3 seconds, until the leds start to flash. Disconnect the Hood using the Main switch or the double-pole switch on the mains power supply. [. . . ]