User manual ROBLIN GRAPHIC 900 DIMENSIONS

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. uSE · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. ⷠNever use the hood for purposes other than for which it has ben designed. [. . . ] ⷠNever leave high naked flames under the hood when it is in operation. ⷠAdjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. ⷠDeep fat fryers must be continuously monitored during use: overheated oil can burst into flames. ⷠThe hood should not be used by children or persons not instructed in its correct use. mAINTENANCE · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. ⷠClean and/or replace the Filters after the specified time period. ⷠClean the hood using a damp cloth and a neutral liquid detergent. Ty Product Components 1 Hood Body, complete with: Controls, Light, Blower, Filters 1 Upper Section (optional) 1 Lower Section (optional) 1 Directional Air Outlet grille 1 Flange (optional) 1 Angle iron (optional) 1 Filter cover On the wall, draw · A Vertical line up to the ceiling or upper limit, at the centre of the area in which the Hood is to be fitted; · A Horizontal line at a minimum of 960 mm above the Cooker Top. Repeat this operation on the other side, checking that the two marks are level. (Reset; check the Maintenance-paragraph) indicates that the activated charcoal odour filter saturation alarm has been triggered , and the filter has to be replaced; the metal grease filters must also be washed. The activated charcoal odour filter is triggered after 200 working hours. REMOTE CONTROL (OPTIONAL) The appliance can be controlled using a remote control powered by a 1. ⷠUsed batteries must be disposed of in the proper manner. ⷠPress button T3 for at least 3 seconds, until the leds start to flash. cleaning the filters · The filters are washable and must be cleaned when led S1 flashes or at least every 2 months of operation, or more frequently for particularly heavy usage. ⷠRemove the filters one at a time by pushing them towards the back of the group and pulling down at the same time. ⷠWhen refitting the filters, make sure that the handle is visible on the outside. ⷠClean the inside using a damp cloth and neutral detergent; do not use wet cloths or sponges, or jets of water; do not use abrasive substances. [. . . ] ⷠWhen refitting the filters, make sure that the handle is visible on the outside. ⷠClean the inside using a damp cloth and neutral detergent; do not use wet cloths or sponges, or jets of water; do not use abrasive substances. The alarm signal will only light up when the extractor motor is switched on. [. . . ]